Hi!

[sorry if this is posted twice! -KS]

Can anyone tell med what changed in the kernel for USB Mass Storage in
the releases after to 2.6.7?

I've attached my .config from Linux 2.6.9. The Mass Storage device (a
USB dongle, mp3 player, camera etc.) is reconized as normal:

Nov 23 21:43:48 qbox usb 5-2: new full speed USB device using address 2
Nov 23 21:43:48 qbox scsi0 : SCSI emulation for USB Mass Storage devices
Nov 23 21:43:48 qbox Vendor: OLYMPUS   Model: u10D,S300D,u300D  Rev: 1011
Nov 23 21:43:48 qbox Type:   Direct-Access                      ANSI
SCSI revision: 02
Nov 23 21:43:49 qbox sda: Spinning up disk....ready
Nov 23 21:43:49 qbox SCSI device sda: 256000 512-byte hdwr sectors (131 MB)
Nov 23 21:43:49 qbox sda: assuming Write Enabled
Nov 23 21:43:49 qbox sda: assuming drive cache: write through
Nov 23 21:43:49 qbox /dev/scsi/host0/bus0/target0/lun0: p1
Nov 23 21:43:50 qbox Attached scsi removable disk sda at scsi0, channel
0, id 0, lun 0
Nov 23 21:43:50 qbox Attached scsi generic sg0 at scsi0, channel 0, id
0, lun 0,  type 0
Nov 23 21:43:50 qbox USB Mass Storage device found at 2
Nov 23 21:43:50 qbox scsi.agent[20209]: disk at
/devices/pci0000:00/0000:00:1d.3/usb5/5-2/5-2:1.0/host0/0:0:0:0



When I try to mount it I get this error:

qbox tmp # mount -t vfat /dev/scsi/host0/bus0/target0/lun0/part1 cam
mount: wrong fs type, bad option, bad superblock on
/dev/scsi/host0/bus0/target0/lun0/part1,
         or too many mounted file systems


Anyone have an idea?


Best regards,

Kristian Sørensen.




-- 
Kristian Sørensen
- The Umbrella Project  --  Security for Consumer Electronics
    http://umbrella.sourceforge.net

E-mail: ipqw@users.sf.net, Phone: +45 29723816