Re: 2 errors in 2.6.12

[Michael Krufky <mkrufky@m1k.net>]

Andrew Morton wrote:

>Michal Semler <cijoml@volny.cz> wrote:
>  
>
>> This is what I gets into dmesg:
>>
>> Linux video capture interface: v1.00
>> bttv: driver version 0.9.15 loaded
>> bttv: using 8 buffers with 2080k (520 pages) each for capture
>> bttv: Bt8xx card found (0).
>> ACPI: PCI Interrupt 0000:01:0b.0[A] -> Link [LNKH] -> GSI 9 (level, low) -> 
>> IRQ 9
>> bttv0: Bt878 (rev 17) at 0000:01:0b.0, irq: 9, latency: 32, mmio: 0xb69fe000
>> bttv0: using: ProVideo PV951 [card=42,insmod option]
>> bttv0: gpio: en=00000000, out=00000000 in=00ffffff [init]
>> bttv0: using tuner=1
>> bttv0: i2c: checking for TDA9875 @ 0xb0... not found
>> bttv0: i2c: checking for TDA7432 @ 0x8a... not found
>> tvaudio: TV audio decoder + audio/video mux driver
>> tvaudio: known chips: 
>> tda9840,tda9873h,tda9874h/a,tda9850,tda9855,tea6300,tea6320,tea6420,tda8425,pic16c54 
>> (PV951),ta8874z
>> tvaudio: found pic16c54 (PV951) @ 0x96
>> bttv0: i2c: checking for TDA9887 @ 0x86... not found
>> tuner: Unknown parameter `type'
>> bttv0: registered device video0
>> bttv0: registered device vbi0
>> bttv0: registered device radio0
>> bttv0: PLL: 28636363 => 35468950 .. ok
>> ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 10
>> PCI: setting IRQ 10 as level-triggered
>> ACPI: PCI Interrupt 0000:01:0c.0[A] -> Link [LNKB] -> GSI 10 (level, low) -> 
>> IRQ 10
>>    
>>
>
>(cc the v4l list)
>
>The above is with 2.6.13-rc4.  2.6.11 was OK.
>  
>
Michael-

Please remove the insmod options:

bttv0: using: ProVideo PV951 [card=42,insmod option]

...and show us dmesg output with autodetection.

Also, please try CVS and tell us if you still have the problem... Instructions at:

http://linuxtv.org/v4lwiki/index.php/How_to_build_from_CVS

-- 
Michael Krufky