Serial driver (serial_core.c) status messages should be set to KERN_INFO

[Alon Bar-Lev <alon.barlev@gmail.com>]

Hello,


When upgrading to 2.6.13 I've noticed that serial driver reports it 
status with unknown severity, causing the boot-splash to be overridden.


Please consider this modification.


Best Regards,

Alon Bar-Lev.


At drivers/serial/serial_core.c


 static inline void

 uart_report_port(struct uart_driver *drv, struct uart_port *port)
 {
-        printk("%s%d", drv->dev_name, port->line);
+      printk(KERN_INFO + "%s%d", drv->dev_name, port->line);

         printk(" at ");
         switch (port->iotype) {
         case UPIO_PORT:
                 printk("I/O 0x%x", port->iobase);
                 break;
         case UPIO_HUB6:
                 printk("I/O 0x%x offset 0x%x", port->iobase, port->hub6);
                 break;
         case UPIO_MEM:
         case UPIO_MEM32:
                 printk("MMIO 0x%lx", port->mapbase);
                 break;
         }
         printk(" (irq = %d) is a %s\n", port->irq, uart_type(port));
 }