Re: MOXA: mxser_new lockup

[Jiri Slaby <jirislaby@gmail.com>]

Jan Kasprzak napsal(a):
> 	Hello,

Hello.

> I have a MOXA C168H card, and after the upgrade from 2.6.19 to 2.6.21-rc6
> (and from moxa.c to mxser_new.c) I get a system lockup after few seconds
> of communicating over the MOXA serial line. Noting is printed on the
> serial console at all. The system is SMP x86_64 (Fedora 5). I may be
> able to do a limited testing on request, but the system is in production
> use most of the time. For now, I will probably move back to the older
> driver.
> 
> 	Are you aware of any SMP or 64-bit issues in mxser_new.c?

No :(. I went through the locking again just now, but I can't see anything
wrong. Could you please enable CONFIG_PROVE_LOCKING and CONFIG_DEBUG_LOCKDEP and
retest?

And also post stty -a -F /dev/ttyMIXX or a setup passed to
tcsetattr/ioctl(TCSETA/S) if available. What do you use for communication?

thanks,
-- 
http://www.fi.muni.cz/~xslaby/            Jiri Slaby
faculty of informatics, masaryk university, brno, cz
e-mail: jirislaby gmail com, gpg pubkey fingerprint:
B674 9967 0407 CE62 ACC8  22A0 32CC 55C3 39D4 7A7E