Re: stallion driver dmesg notice

[Jiri Slaby <jirislaby@gmail.com>]

Ingo Korb napsal(a):
> Hi!
> 
> The stallion driver in 2.6.21.3 put this little notice in my dmesg:
> 
> === Cut ===
> Stallion Multiport Serial Driver: version 5.6.0
> stallion 0000:00:0b.0: please, report this to LKML: 100b/d001/ffffff
> ACPI: PCI Interrupt 0000:00:0b.0[A] -> GSI 19 (level, low) -> IRQ 17
> stallion: probe of 0000:00:0b.0 failed with error -16
> === Cut ===
> 
> The card is a EC8/32-PCI with a single connected panel. It used to work 
> well with 2.4, mostly well with a patched 2.6.8.1, really bad 
> (unstable, lost characters) with 2.6.11(?) and doesn't work at all with 
> 2.6.21.3.
> 
> Should I test it with an EC8/64-PCI? The /32 (ab)uses an IDE controller 
> chip as PCI interface, the /64 uses a PLX PCI9050.
> 
> lspci -vv for the EC8/32:
> === Cut ===
> 00:0b.0 Class ffff: National Semiconductor Corporation 87410 IDE (rev 
> ff) (prog-if ff)
> 	Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- 
> Stepping- SERR- FastB2B-
> 	Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- 
> <TAbort- <MAbort- >SERR- <PERR-
> 	Interrupt: pin A routed to IRQ 17
> 	Region 0: I/O ports at d100 [size=8]
> 	Region 1: I/O ports at d200 [size=4]
> 	Region 2: I/O ports at d300 [size=8]
> 	Region 3: I/O ports at d400 [size=4]
> === Cut ===

Thanks. I will look into it,
-- 
http://www.fi.muni.cz/~xslaby/            Jiri Slaby
faculty of informatics, masaryk university, brno, cz
e-mail: jirislaby gmail com, gpg pubkey fingerprint:
B674 9967 0407 CE62 ACC8  22A0 32CC 55C3 39D4 7A7E