[PATCH 01/18] MMC: OMAP: Remove some opcodes from host driver

[Carlos Aguiar <carlos.aguiar@indt.org.br>]

From: Carlos Eduardo Aguiar <carlos.aguiar@indt.org.br>

This patch removes some opcodes from host driver so there's no need on putting
'#include <linux/mmc/mmc.h>', that should not be needed in host drivers.

Signed-off-by: Carlos Eduardo Aguiar <carlos.aguiar@indt.org.br>
---
 drivers/mmc/host/omap.c |   11 +++--------
 1 files changed, 3 insertions(+), 8 deletions(-)

diff --git a/drivers/mmc/host/omap.c b/drivers/mmc/host/omap.c
index c9dfeb1..eb7175a 100644
--- a/drivers/mmc/host/omap.c
+++ b/drivers/mmc/host/omap.c
@@ -495,15 +495,10 @@ static irqreturn_t mmc_omap_irq(int irq, void *dev_id)
 		if (status & OMAP_MMC_STAT_CMD_TOUT) {
 			/* Timeouts are routine with some commands */
 			if (host->cmd) {
-				if (host->cmd->opcode != MMC_ALL_SEND_CID &&
-						host->cmd->opcode !=
-						MMC_SEND_OP_COND &&
-						host->cmd->opcode !=
-						MMC_APP_CMD &&
-						!mmc_omap_cover_is_open(host))
+				if (!mmc_omap_cover_is_open(host))
 					dev_err(mmc_dev(host->mmc),
-						"command timeout, CMD %d\n",
-						host->cmd->opcode);
+					"command timeout, CMD %d\n",
+					host->cmd->opcode);
 				host->cmd->error = -ETIMEDOUT;
 				end_command = 1;
 			}
-- 1.5.3.GIT