[PATCH] x86: k8 numa register active regions later

[Yinghai Lu <yinghai@kernel.org>]

Impact: clean up

don't register early, so we don't need to clear actived regions if it fail
to get node hash shift or wild set in nb config.

also remove nodeids array that is not needed

Signed-off-by: Yinghai Lu <yinghai@kernel.org>
---
 arch/x86/mm/k8topology_64.c |   20 +++++++++-----------
 1 file changed, 9 insertions(+), 11 deletions(-)

Index: linux-2.6/arch/x86/mm/k8topology_64.c
===================================================================
--- linux-2.6.orig/arch/x86/mm/k8topology_64.c
+++ linux-2.6/arch/x86/mm/k8topology_64.c
@@ -81,7 +81,6 @@ int __init k8_scan_nodes(unsigned long s
 	unsigned numnodes, cores, bits, apicid_base;
 	unsigned long prevbase;
 	struct bootnode nodes[8];
-	unsigned char nodeids[8];
 	int i, j, nb, found = 0;
 	u32 nodeid, reg;
 
@@ -110,7 +109,6 @@ int __init k8_scan_nodes(unsigned long s
 		limit = read_pci_config(0, nb, 1, 0x44 + i*8);
 
 		nodeid = limit & 7;
-		nodeids[i] = nodeid;
 		if ((base & 3) == 0) {
 			if (i < numnodes)
 				printk("Skipping disabled node %d\n", i);
@@ -179,9 +177,6 @@ int __init k8_scan_nodes(unsigned long s
 
 		nodes[nodeid].start = base;
 		nodes[nodeid].end = limit;
-		e820_register_active_regions(nodeid,
-				nodes[nodeid].start >> PAGE_SHIFT,
-				nodes[nodeid].end >> PAGE_SHIFT);
 
 		prevbase = base;
 
@@ -211,12 +206,15 @@ int __init k8_scan_nodes(unsigned long s
 	}
 
 	for (i = 0; i < 8; i++) {
-		if (nodes[i].start != nodes[i].end) {
-			nodeid = nodeids[i];
-			for (j = apicid_base; j < cores + apicid_base; j++)
-				apicid_to_node[(nodeid << bits) + j] = i;
-			setup_node_bootmem(i, nodes[i].start, nodes[i].end);
-		}
+		if (nodes[i].start == nodes[i].end)
+			continue;
+
+		e820_register_active_regions(i,
+				nodes[i].start >> PAGE_SHIFT,
+				nodes[i].end >> PAGE_SHIFT);
+		for (j = apicid_base; j < cores + apicid_base; j++)
+			apicid_to_node[(i << bits) + j] = i;
+		setup_node_bootmem(i, nodes[i].start, nodes[i].end);
 	}
 
 	numa_init_array();