From: Michael Riepe <michael.riepe@googlemail.com>
To: Michael Buesch <mb@bu3sch.de>
Cc: "Francois Romieu" <romieu@fr.zoreil.com>,
"Rui Santos" <rsantos@grupopie.com>,
"Michael Büker" <m.bueker@berlin.de>,
linux-kernel@vger.kernel.org
Subject: Re: 2.6.27.19 + 28.7: network timeouts for r8169 and 8139too
Date: Sun, 10 May 2009 15:38:26 +0200 [thread overview]
Message-ID: <4A06D8D2.4010505@googlemail.com> (raw)
In-Reply-To: <200904041950.04324.mb@bu3sch.de>
Michael Buesch wrote:
> I'm currently testing 2.6.29.1 without any additional patches but
> with the pci=nomsi boot option.
>
> I didn't notice any hickups, yet. I'm running a stresstest on a GBit link for quite
> some time now. Earlier tests with older kernels and MSI burped earlier.
>
> I will do more testing. If it turns out this is stable I will test the same kernel
> with Message Signaled Interrupts to see if that causes some breakage.
I've had this problem up to and including 2.6.29.2. Currently, I'm
trying 2.6.29.2 with pci=nomsi, and it's stable so far. With MSI
enabled, a single high-speed TCP transfer will stop after a few seconds,
but without MSI, I can run four simultaneous transfers to two different
hosts without a single hickup.
It seems to me that this particular chip really doesn't like MSI.
Kernel: 2.6.29.2 (x86_64)
Board: Intel D945GCLF2
BIOS version: LF94510J.86A.0099.2008.0731.0303
lspci -vv:
01:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd.
RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 02)
Subsystem: Intel Corporation Device 0001
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 64 bytes
Interrupt: pin A routed to IRQ 16
Region 0: I/O ports at 1000 [size=256]
Region 2: Memory at 90100000 (64-bit, non-prefetchable) [size=4K]
Region 4: Memory at 90000000 (64-bit, prefetchable) [size=64K]
Expansion ROM at 90020000 [disabled] [size=128K]
Capabilities: [40] Power Management version 3
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=375mA
PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [50] MSI: Mask- 64bit+ Count=1/1 Enable-
Address: 0000000000000000 Data: 0000
Capabilities: [70] Express (v1) Endpoint, MSI 01
DevCap: MaxPayload 256 bytes, PhantFunc 0, Latency L0s
<512ns, L1 <64us
ExtTag- AttnBtn- AttnInd- PwrInd- RBE+ FLReset-
DevCtl: Report errors: Correctable- Non-Fatal- Fatal-
Unsupported-
RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop-
MaxPayload 128 bytes, MaxReadReq 4096 bytes
DevSta: CorrErr- UncorrErr- FatalErr- UnsuppReq- AuxPwr+
TransPend-
LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s L1,
Latency L0 <512ns, L1 <64us
ClockPM+ Suprise- LLActRep- BwNot-
LnkCtl: ASPM Disabled; RCB 64 bytes Disabled- Retrain-
CommClk+
ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-
LnkSta: Speed 2.5GT/s, Width x1, TrErr- Train- SlotClk+
DLActive- BWMgmt- ABWMgmt-
Capabilities: [b0] MSI-X: Enable- Mask- TabSize=2
Vector table: BAR=4 offset=00000000
PBA: BAR=4 offset=00000800
Capabilities: [d0] Vital Product Data <?>
Kernel driver in use: r8169
Kernel modules: r8169
--
Michael "Tired" Riepe <michael.riepe@googlemail.com>
X-Tired: Each morning I get up I die a little
next prev parent reply other threads:[~2009-05-10 13:38 UTC|newest]
Thread overview: 106+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-03-04 17:28 2.6.27.19 + 28.7: network timeouts for r8169 and 8139too Michael Büker
2009-03-04 22:43 ` Francois Romieu
2009-03-06 0:17 ` Michael Büker
2009-03-08 10:27 ` Tom Weber
2009-03-10 5:42 ` Tom Weber
2009-03-09 12:07 ` Rui Santos
2009-03-13 18:29 ` Rui Santos
2009-03-16 13:07 ` Rui Santos
2009-03-22 21:12 ` Francois Romieu
2009-03-22 21:19 ` Michael Buesch
2009-03-22 22:00 ` Francois Romieu
2009-03-22 22:09 ` Michael Buesch
2009-03-22 22:27 ` Francois Romieu
2009-03-22 22:38 ` Michael Buesch
2009-03-23 11:47 ` Michael Buesch
2009-03-23 12:47 ` Michael Buesch
2009-03-23 23:47 ` Francois Romieu
2009-03-24 9:43 ` Michael Buesch
2009-03-23 14:29 ` Michael Büker
2009-03-23 14:57 ` Rui Santos
2009-03-23 15:04 ` Michael Büker
2009-03-25 11:40 ` Rui Santos
2009-04-04 17:50 ` Michael Buesch
2009-05-10 13:38 ` Michael Riepe [this message]
2009-05-10 15:01 ` Michael S. Zick
2009-05-10 15:10 ` Michael S. Zick
2009-05-10 15:53 ` Michael Buesch
2009-05-10 16:27 ` Michael Riepe
2009-05-10 17:09 ` Michael S. Zick
2009-05-11 0:29 ` David Dillow
2009-05-11 20:48 ` Michael Buesch
2009-05-11 21:10 ` Michael Buesch
2009-05-11 21:29 ` David Dillow
2009-05-11 21:59 ` Michael Buesch
2009-05-12 20:29 ` Michael Riepe
2009-05-14 2:38 ` David Dillow
2009-05-14 18:37 ` Michael Riepe
2009-05-14 19:14 ` David Dillow
2009-05-14 19:42 ` Michael Riepe
2009-05-23 1:29 ` [PATCH 2.6.30-rc4] r8169: avoid losing MSI interrupts David Dillow
2009-05-23 9:24 ` Michael Buesch
2009-05-23 14:35 ` Michael Riepe
2009-05-23 14:44 ` Michael Buesch
2009-05-23 15:01 ` Michael Riepe
2009-05-23 16:40 ` Michael Buesch
2009-05-23 14:51 ` David Dillow
2009-05-23 16:12 ` Michael Riepe
2009-05-23 16:45 ` Michael Buesch
2009-05-23 16:46 ` David Dillow
2009-05-23 16:50 ` Michael Buesch
2009-05-23 16:53 ` Michael Riepe
2009-05-23 17:03 ` David Dillow
2009-05-24 21:15 ` Francois Romieu
2009-05-24 22:55 ` David Dillow
2009-05-26 5:55 ` David Miller
2009-05-26 18:22 ` Michael Buesch
2009-05-26 21:52 ` David Miller
2009-05-26 22:14 ` David Miller
2009-05-26 22:40 ` Michael Riepe
2009-05-26 22:43 ` David Miller
2009-05-26 23:10 ` David Miller
2009-05-27 16:19 ` Michael Buesch
2009-06-16 19:32 ` Rui Santos
2009-08-21 20:57 ` Eric W. Biederman
2009-08-21 21:22 ` Michael Riepe
2009-08-21 22:59 ` David Dillow
2009-08-21 23:34 ` David Dillow
2009-08-22 0:24 ` Eric W. Biederman
2009-08-22 11:48 ` Eric W. Biederman
2009-08-22 12:07 ` Eric W. Biederman
2009-08-22 20:43 ` David Dillow
2009-08-23 17:17 ` Jarek Poplawski
2009-08-23 17:43 ` Michal Soltys
2009-08-23 17:54 ` Jarek Poplawski
2009-08-24 2:37 ` Eric W. Biederman
2009-08-25 0:51 ` Eric W. Biederman
2009-08-25 2:59 ` David Dillow
2009-08-25 20:22 ` Eric W. Biederman
2009-08-25 20:40 ` David Dillow
2009-08-25 21:24 ` Eric W. Biederman
2009-08-25 21:46 ` David Dillow
2009-08-25 22:19 ` Francois Romieu
2009-08-26 3:47 ` Eric W. Biederman
2009-08-26 7:58 ` [PATCH] r8169: Reduce looping in the interrupt handler Eric W. Biederman
2009-08-26 13:56 ` David Dillow
2009-08-26 13:59 ` David Dillow
2009-08-26 20:02 ` Eric W. Biederman
2009-08-26 21:30 ` Francois Romieu
2009-08-26 21:40 ` Eric W. Biederman
2009-08-27 5:24 ` Francois Romieu
2009-08-27 5:38 ` Eric W. Biederman
2009-08-27 23:20 ` Francois Romieu
2009-08-28 1:17 ` Eric W. Biederman
2009-08-28 1:29 ` David Dillow
2009-08-30 20:37 ` Francois Romieu
2009-08-30 20:53 ` Eric W. Biederman
2009-09-01 3:33 ` David Dillow
2009-09-01 9:20 ` Francois Romieu
2009-08-25 21:37 ` [PATCH 2.6.30-rc4] r8169: avoid losing MSI interrupts Eric W. Biederman
2009-08-25 21:54 ` David Dillow
2009-08-25 23:11 ` Francois Romieu
2009-05-12 11:10 ` 2.6.27.19 + 28.7: network timeouts for r8169 and 8139too Krzysztof Halasa
2009-05-12 21:45 ` Michael Riepe
2009-05-13 6:11 ` Francois Romieu
2009-05-13 6:27 ` Michael Riepe
2009-05-13 19:34 ` Krzysztof Halasa
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4A06D8D2.4010505@googlemail.com \
--to=michael.riepe@googlemail.com \
--cc=linux-kernel@vger.kernel.org \
--cc=m.bueker@berlin.de \
--cc=mb@bu3sch.de \
--cc=romieu@fr.zoreil.com \
--cc=rsantos@grupopie.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox