Re: [PATCH] serial: Two branches the same in timbuart_set_mctrl()

[Roel Kluin <roel.kluin@gmail.com>]

Dear Richard Röjfors,

It is possible that I found a bug in the Timberdale UART driver that was added
to the linux kernel. The patch below tries to fix this, note the RTS to CTS
change, could you confirm whether the patch below changes your driver
correctly?

Thank you,

Roel Kluin
----------------->8----------------------------8<-------------------------------
Regardless of whether the TIOCM_RTS bit was set in mctrl, the same write
occurred.

Signed-off-by: Roel Kluin <roel.kluin@gmail.com>
---
 drivers/serial/timbuart.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/serial/timbuart.c b/drivers/serial/timbuart.c
index 34b31da..c433d40 100644
--- a/drivers/serial/timbuart.c
+++ b/drivers/serial/timbuart.c
@@ -219,7 +219,7 @@ static void timbuart_set_mctrl(struct uart_port *port, unsigned int mctrl)
 	if (mctrl & TIOCM_RTS)
 		iowrite8(TIMBUART_CTRL_RTS, port->membase + TIMBUART_CTRL);
 	else
-		iowrite8(TIMBUART_CTRL_RTS, port->membase + TIMBUART_CTRL);
+		iowrite8(TIMBUART_CTRL_CTS, port->membase + TIMBUART_CTRL);
 }
 
 static void timbuart_mctrl_check(struct uart_port *port, u32 isr, u32 *ier)