From: Adrian Hunter <adrian.hunter@intel.com>
To: <rohan1sj@cadence.com>, Ulf Hansson <ulf.hansson@linaro.org>,
Rob Herring <robh@kernel.org>,
Krzysztof Kozlowski <krzk+dt@kernel.org>,
Conor Dooley <conor+dt@kernel.org>,
Masahiro Yamada <yamada.masahiro@socionext.com>
Cc: <linux-mmc@vger.kernel.org>, <devicetree@vger.kernel.org>,
<linux-kernel@vger.kernel.org>, Milind Parab <mparab@cadence.com>,
"Swapnil Jakhade" <sjakhade@cadence.com>,
Manikandan Pillai <mpillai@cadence.com>
Subject: Re: [PATCH 2/2] mmc: cqe: Add CQE support for cadence mmc driver
Date: Tue, 5 May 2026 12:51:49 +0300 [thread overview]
Message-ID: <5002f40e-9b8e-4454-81c8-986dbb0768b6@intel.com> (raw)
In-Reply-To: <20260407-cdns_sdhci_cqe-support-v1-2-13efc0810631@cadence.com>
On 07/04/2026 14:18, rohan1sj via B4 Relay wrote:
> From: rohan1sj <rohan1sj@cadence.com>
>
> Add Command Queuing Engine (CQE) support for cadence driver
>
> Signed-off-by: rohan1sj <rohan1sj@cadence.com>
> ---
> drivers/mmc/host/sdhci-cadence.c | 118 ++++++++++++++++++++++++++++++++++++++-
> 1 file changed, 115 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/mmc/host/sdhci-cadence.c b/drivers/mmc/host/sdhci-cadence.c
> index 435603c8c00b..14b12272dae9 100644
> --- a/drivers/mmc/host/sdhci-cadence.c
> +++ b/drivers/mmc/host/sdhci-cadence.c
> @@ -15,6 +15,8 @@
> #include <linux/reset.h>
>
> #include "sdhci-pltfm.h"
> +#include "sdhci-cqhci.h"
> +#include "cqhci.h"
Also need to select MMC_CQHCI in Kconfig for MMC_SDHCI_CADENCE
>
> /* HRS - Host Register Set (specific to Cadence) */
> #define SDHCI_CDNS_HRS04 0x10 /* PHY access port */
> @@ -36,6 +38,10 @@
> #define SDHCI_CDNS_HRS06_MODE_MMC_HS400 0x5
> #define SDHCI_CDNS_HRS06_MODE_MMC_HS400ES 0x6
>
> +/* Host capabilities not covered by the standard capability registers (SRS16-SRS18) */
> +#define SDHCI_CDNS_HRS30 0x78 /* Host capabilities */
> +#define SDHCI_CDNS_HRS30_CQE_SUPPORTED BIT(0)
> +
> /* Read block gap */
> #define SDHCI_CDNS_HRS37 0x94 /* interface mode select */
> #define SDHCI_CDNS_HRS37_MODE_DS 0x0
> @@ -88,6 +94,7 @@ struct sdhci_cdns_priv {
> void __iomem *ctl_addr; /* write control */
> spinlock_t wrlock; /* write lock */
> bool enhanced_strobe;
> + bool cqe_support; /* Command Queuing Engine support */
> void (*priv_writel)(struct sdhci_cdns_priv *priv, u32 val, void __iomem *reg);
> struct reset_control *rst_hw;
> unsigned int nr_phy_params;
> @@ -385,6 +392,73 @@ static void sdhci_cdns_set_uhs_signaling(struct sdhci_host *host,
> sdhci_set_uhs_signaling(host, timing);
> }
>
> +static u32 sdhci_cdns_cqhci_irq(struct sdhci_host *host, u32 intmask)
> +{
> + int cmd_err = 0;
> + int data_err = 0;
> +
> + /* return original intmask to be handled by other handlers if it's not a CQE interrupt */
> + if (!sdhci_cqe_irq(host, intmask, &cmd_err, &data_err))
> + return intmask;
> +
> + cqhci_irq(host->mmc, intmask, cmd_err, data_err);
> +
> + return 0;
> +}
> +
> +static const struct cqhci_host_ops sdhci_cdns_cqhci_ops = {
> + .enable = sdhci_cqe_enable,
> + .disable = sdhci_cqe_disable,
> +};
> +
> +static int sdhci_cdns_cqe_add_host(struct sdhci_host *host, struct platform_device *pdev)
> +{
> + struct cqhci_host *cq_host;
> + bool dma64;
> + int ret;
> +
> + /* setup SDHCI host first */
> + ret = sdhci_setup_host(host);
> +
Unnecessary blank line
> + if (ret)
> + return ret;
> +
> + /* Init CQE */
> + cq_host = cqhci_pltfm_init(pdev);
> + if (IS_ERR(cq_host)) {
> + ret = PTR_ERR(cq_host);
> + goto cleanup;
> + }
> +
> + dma64 = host->flags & SDHCI_USE_64_BIT_DMA;
> + if (dma64)
> + cq_host->caps |= CQHCI_TASK_DESC_SZ_128;
> +
> + cq_host->ops = &sdhci_cdns_cqhci_ops;
> +
> + host->mmc->caps2 |= MMC_CAP2_CQE | MMC_CAP2_CQE_DCMD;
> +
> + /* Finally initialize CQHCI */
> + ret = cqhci_init(cq_host, host->mmc, dma64);
> + if (ret) {
> + dev_err(mmc_dev(host->mmc), "Failed to initialize CQHCI: %d\n", ret);
> + goto cleanup;
> + }
> +
> + /* add host to MMC subsystem */
> + ret = __sdhci_add_host(host);
> + if (ret)
> + goto cleanup;
> +
> + dev_info(mmc_dev(host->mmc), "CQE init: success\n");
> + return 0;
> +
> +cleanup:
> + dev_err(mmc_dev(host->mmc), "CQE init: failed for %s\n", mmc_hostname(host->mmc));
> + sdhci_cleanup_host(host);
> + return ret;
> +}
> +
> /* Elba control register bits [6:3] are byte-lane enables */
> #define ELBA_BYTE_ENABLE_MASK(x) ((x) << 3)
>
> @@ -474,9 +548,10 @@ static const struct sdhci_ops sdhci_cdns_ops = {
> .set_clock = sdhci_set_clock,
> .get_timeout_clock = sdhci_cdns_get_timeout_clock,
> .set_bus_width = sdhci_set_bus_width,
> - .reset = sdhci_reset,
> + .reset = sdhci_and_cqhci_reset,
> .platform_execute_tuning = sdhci_cdns_execute_tuning,
> .set_uhs_signaling = sdhci_cdns_set_uhs_signaling,
> + .irq = sdhci_cdns_cqhci_irq,
> };
sdhci_elba_ops is unchanged, so presumably doesn't support CQE.
However, the commit message should say something about that so
that it is clear that it is deliberate.
>
> static const struct sdhci_cdns_drv_data sdhci_cdns_uniphier_drv_data = {
> @@ -553,6 +628,8 @@ static int sdhci_cdns_probe(struct platform_device *pdev)
> int ret;
> struct device *dev = &pdev->dev;
> static const u16 version = SDHCI_SPEC_400 << SDHCI_SPEC_VER_SHIFT;
> + bool cqe_enabled;
> + u32 host_caps;
>
> clk = devm_clk_get_enabled(dev, NULL);
> if (IS_ERR(clk))
> @@ -608,7 +685,35 @@ static int sdhci_cdns_probe(struct platform_device *pdev)
> host->mmc_host_ops.card_hw_reset = sdhci_cdns_mmc_hw_reset;
> }
>
> - return sdhci_add_host(host);
> + host_caps = readl(priv->hrs_addr + SDHCI_CDNS_HRS30);
> + cqe_enabled = host_caps & SDHCI_CDNS_HRS30_CQE_SUPPORTED;
> +
> + if (cqe_enabled) {
> + priv->cqe_support = true;
> + ret = sdhci_cdns_cqe_add_host(host, pdev);
> + } else {
> + ret = sdhci_add_host(host);
> + }
> +
> + return ret;
> +}
> +
> +static int sdhci_cdns_suspend(struct device *dev)
> +{
> + struct sdhci_host *host = dev_get_drvdata(dev);
> + struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
> + struct sdhci_cdns_priv *priv = sdhci_pltfm_priv(pltfm_host);
> + int ret;
> +
> + if (priv->cqe_support) {
> + ret = cqhci_suspend(host->mmc);
> + if (ret)
> + return ret;
> + }
> +
> + ret = sdhci_pltfm_suspend(dev);
> +
> + return ret;
> }
>
> static int sdhci_cdns_resume(struct device *dev)
> @@ -630,6 +735,13 @@ static int sdhci_cdns_resume(struct device *dev)
> if (ret)
> goto disable_clk;
>
> + /* Resume CQE if enabled */
> + if (priv->cqe_support) {
> + ret = cqhci_resume(host->mmc);
> + if (ret)
> + goto disable_clk;
> + }
> +
> return 0;
>
> disable_clk:
> @@ -638,7 +750,7 @@ static int sdhci_cdns_resume(struct device *dev)
> return ret;
> }
>
> -static DEFINE_SIMPLE_DEV_PM_OPS(sdhci_cdns_pm_ops, sdhci_pltfm_suspend, sdhci_cdns_resume);
> +static DEFINE_SIMPLE_DEV_PM_OPS(sdhci_cdns_pm_ops, sdhci_cdns_suspend, sdhci_cdns_resume);
>
> static const struct of_device_id sdhci_cdns_match[] = {
> {
>
prev parent reply other threads:[~2026-05-05 9:52 UTC|newest]
Thread overview: 6+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-04-07 11:18 [PATCH 0/2] CQE support for cadence eMMC host controller rohan1sj via B4 Relay
2026-04-07 11:18 ` [PATCH 1/2] mmc: cqe: Add CQE DT support for cadence controller rohan1sj via B4 Relay
2026-04-07 11:30 ` Krzysztof Kozlowski
2026-04-07 11:18 ` [PATCH 2/2] mmc: cqe: Add CQE support for cadence mmc driver rohan1sj via B4 Relay
2026-04-07 11:30 ` Krzysztof Kozlowski
2026-05-05 9:51 ` Adrian Hunter [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=5002f40e-9b8e-4454-81c8-986dbb0768b6@intel.com \
--to=adrian.hunter@intel.com \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=krzk+dt@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mmc@vger.kernel.org \
--cc=mparab@cadence.com \
--cc=mpillai@cadence.com \
--cc=robh@kernel.org \
--cc=rohan1sj@cadence.com \
--cc=sjakhade@cadence.com \
--cc=ulf.hansson@linaro.org \
--cc=yamada.masahiro@socionext.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox