From: Jens Axboe <axboe@kernel.dk>
To: Linus Torvalds <torvalds@linux-foundation.org>
Cc: "linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>
Subject: [GIT PULL] block driver bits for 3.7
Date: Mon, 29 Oct 2012 19:21:26 +0100 [thread overview]
Message-ID: <508EC926.3040906@kernel.dk> (raw)
Hi Linus,
Later than I would have liked, but I was traveling around the merge
window and then a fixes snuck in past that and I wanted to ensure that
everything was fully baked again. There was a particular issue around a
floppy regression due to the genhd change, which has now gotten
reverted. So without further ado, here are the driver updates queued up
for 3.7. It contains:
- Updates to the Micron mtip32xx real-ssd card from Micron.
- A few fixes for loop, from Dave Chinner and Eric Biederman.
- A round of floppy fixes, and a subsequent revert of genhd
part since it caused regressions.
- The usual round of drbd updates/fixes.
- A single xen-blkback fixup.
- A few other minor fixes and/or code cleanups.
- memstick driver and later revert, this isn't well reviewed
enough yet to go directly in.
Please pull!
git://git.kernel.dk/linux-block.git for-3.7/drivers
for you to fetch changes up to a13c29ddf73d3be4fbb2b1bbced64014986cd87a:
Merge branch 'for-jens' of git://git.kernel.org/pub/scm/linux/kernel/git/jikos/linux-block into for-3.7/drivers (2012-10-29 19:20:25 +0100)
----------------------------------------------------------------
Akinobu Mita (1):
cciss: select CONFIG_CHECK_SIGNATURE
Asai Thambi S P (6):
mtip32xx: Add support for new devices
mtip32xx: Handle NCQ commands during the security locked state
mtip32xx: Increase timeout for standby command
mtip32xx: Proper reporting of write protect status on big-endian
mtip32xx: Change printk to pr_xxxx
mtip32xx: Remove dead code
Ben Hutchings (1):
genhd: Make put_disk() safe for disks that have not been registered
Dave Chinner (1):
loop: Make explicit loop device destruction lazy
David Milburn (1):
mtip32xx: fix user_buffer check in exec_drive_command
Eric W. Biederman (1):
userns: Convert loop to use kuid_t instead of uid_t
Herton Ronaldo Krzesinski (5):
floppy: don't call alloc_ordered_workqueue inside the alloc_disk loop
floppy: do put_disk on current dr if blk_init_queue fails
floppy: properly handle failure on add_disk loop
floppy: use common function to check if floppies can be registered
floppy: remove dr, reuse drive on do_floppy_init
Jens Axboe (6):
Merge branch 'stable/for-jens-3.7' of git://git.kernel.org/.../konrad/xen into for-3.7/drivers
Merge branch 'for-jens' of git://git.kernel.org/.../jikos/linux-block into for-3.7/drivers
Merge branch 'stable/for-jens-3.7' of git://git.kernel.org/.../konrad/xen into for-3.7/drivers
Merge branch 'for-3.7/core' into for-3.7/drivers
Revert "memstick: add support for legacy memorysticks"
Merge branch 'for-jens' of git://git.kernel.org/.../jikos/linux-block into for-3.7/drivers
Jiri Kosina (3):
pktcdvd: update MAINTAINERS
Merge branches 'floppy' and 'pktcdvd' into for-jens
Revert "genhd: Make put_disk() safe for disks that have not been registered"
Konrad Rzeszutek Wilk (1):
xen/blkback: Fix compile warning
Lars Ellenberg (8):
drbd: introduce stop-sector to online verify
drbd: panic on delayed completion of aborted requests
drbd: fix potential deadlock during bitmap (re-)allocation
drbd: a few more GFP_KERNEL -> GFP_NOIO
drbd: wait for meta data IO completion even with failed disk, unless force-detached
drbd: prepare for more than 32 bit flags
drbd: always write bitmap on detach
drbd: log request sector offset and size for IO errors
Maxim Levitsky (1):
memstick: add support for legacy memorysticks
Oliver Chick (1):
xen/blkback: Change xen_vbd's flush_support and discard_secure to have type unsigned int, rather than bool
Philipp Reisner (4):
drbd: Protect accesses to the uuid set with a spinlock
drbd: Fix a potential issue with the DISCARD_CONCURRENT flag
drbd: Avoid NetworkFailure state during disconnect
drbd: Remove dead code
Selvan Mani (1):
mtip32xx:Added appropriate timeout value for secure erase
Wei Yongjun (2):
xen/blkback: use kmem_cache_zalloc instead of kmem_cache_alloc/memset
cciss: remove unneeded memset()
MAINTAINERS | 2 +-
drivers/block/Kconfig | 1 +
drivers/block/cciss.c | 1 -
drivers/block/drbd/drbd_actlog.c | 19 ++--
drivers/block/drbd/drbd_bitmap.c | 24 ++---
drivers/block/drbd/drbd_int.h | 108 +++++++++++++++++------
drivers/block/drbd/drbd_main.c | 170 ++++++++++++++++++++++++------------
drivers/block/drbd/drbd_nl.c | 74 +++++++++-------
drivers/block/drbd/drbd_proc.c | 14 ++-
drivers/block/drbd/drbd_receiver.c | 147 ++++++++++++++++---------------
drivers/block/drbd/drbd_req.c | 43 ++++++---
drivers/block/drbd/drbd_worker.c | 87 ++++++++++++++----
drivers/block/floppy.c | 86 ++++++++++--------
drivers/block/loop.c | 21 ++++-
drivers/block/mtip32xx/mtip32xx.c | 57 ++++++++----
drivers/block/mtip32xx/mtip32xx.h | 13 ++-
drivers/block/xen-blkback/common.h | 4 +-
drivers/block/xen-blkback/xenbus.c | 9 +-
include/linux/drbd.h | 4 +-
include/linux/drbd_nl.h | 1 +
include/linux/loop.h | 2 +-
init/Kconfig | 1 -
22 files changed, 575 insertions(+), 313 deletions(-)
--
Jens Axboe
next reply other threads:[~2012-10-29 18:21 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-10-29 18:21 Jens Axboe [this message]
2012-10-29 18:35 ` [GIT PULL] block driver bits for 3.7 Linus Torvalds
2012-10-29 19:13 ` Jens Axboe
-- strict thread matches above, loose matches on Subject: below --
2012-10-30 13:25 Jens Axboe
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=508EC926.3040906@kernel.dk \
--to=axboe@kernel.dk \
--cc=linux-kernel@vger.kernel.org \
--cc=torvalds@linux-foundation.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).