[PATCH v9 17/20] mfd: omap-usb-host: Get rid of unnecessary spinlock

Roger Quadros
2013-01-23T10:40:36Z

The driver does not have an interrupt handler and
we don't really need a spinlock, so get rid of it.

Signed-off-by: Roger Quadros <rogerq@ti.com>
Reviewed-by: Felipe Balbi <balbi@ti.com>
---
drivers/mfd/omap-usb-host.c | 16 ----------------
1 files changed, 0 insertions(+), 16 deletions(-)

diff --git a/drivers/mfd/omap-usb-host.c b/drivers/mfd/omap-usb-host.c
index bdfc8b7..0740c68 100644
--- a/drivers/mfd/omap-usb-host.c
+++ b/drivers/mfd/omap-usb-host.c
@@ -23,7 +23,6 @@
#include <linux/delay.h>
#include <linux/clk.h>
#include <linux/dma-mapping.h>
-#include <linux/spinlock.h>
#include <linux/gpio.h>
#include <linux/platform_device.h>
#include <linux/platform_data/usb-omap.h>
@@ -108,7 +107,6 @@ struct usbhs_hcd_omap {
struct usbhs_omap_platform_data *pdata;

u32 usbhs_rev;
- spinlock_t lock;
};
/*-------------------------------------------------------------------------*/

@@ -276,13 +274,11 @@ static int usbhs_runtime_resume(struct device *dev)
{
struct usbhs_hcd_omap *omap = dev_get_drvdata(dev);
struct usbhs_omap_platform_data *pdata = omap->pdata;
- unsigned long flags;
int i, r;

dev_dbg(dev, "usbhs_runtime_resume\n");

omap_tll_enable();
- spin_lock_irqsave(&omap->lock, flags);

if (!IS_ERR(omap->ehci_logic_fck))
clk_enable(omap->ehci_logic_fck);
@@ -324,8 +320,6 @@ static int usbhs_runtime_resume(struct device *dev)
}
}

- spin_unlock_irqrestore(&omap->lock, flags);
-
return 0;
}

@@ -333,13 +327,10 @@ static int usbhs_runtime_suspend(struct device *dev)
{
struct usbhs_hcd_omap *omap = dev_get_drvdata(dev);
struct usbhs_omap_platform_data *pdata = omap->pdata;
- unsigned long flags;
int i;

dev_dbg(dev, "usbhs_runtime_suspend\n");

- spin_lock_irqsave(&omap->lock, flags);
-
for (i = 0; i < omap->nports; i++) {
switch (pdata->port_mode[i]) {
case OMAP_EHCI_PORT_MODE_HSIC:
@@ -362,7 +353,6 @@ static int usbhs_runtime_suspend(struct device *dev)
if (!IS_ERR(omap->ehci_logic_fck))
clk_disable(omap->ehci_logic_fck);

- spin_unlock_irqrestore(&omap->lock, flags);
omap_tll_disable();

return 0;
@@ -372,7 +362,6 @@ static void omap_usbhs_init(struct device *dev)
{
struct usbhs_hcd_omap *omap = dev_get_drvdata(dev);
struct usbhs_omap_platform_data *pdata = omap->pdata;
- unsigned long flags;
unsigned reg;

dev_dbg(dev, "starting TI HSUSB Controller\n");
@@ -391,7 +380,6 @@ static void omap_usbhs_init(struct device *dev)
}

pm_runtime_get_sync(dev);
- spin_lock_irqsave(&omap->lock, flags);

reg = usbhs_read(omap->uhh_base, OMAP_UHH_HOSTCONFIG);
/* setup ULPI bypass and burst configurations */
@@ -454,8 +442,6 @@ static void omap_usbhs_init(struct device *dev)
usbhs_write(omap->uhh_base, OMAP_UHH_HOSTCONFIG, reg);
dev_dbg(dev, "UHH setup done, uhh_hostconfig=%x\n", reg);

- spin_unlock_irqrestore(&omap->lock, flags);
-
pm_runtime_put_sync(dev);
if (pdata->phy_reset) {
/* Hold the PHY in RESET for enough time till
@@ -521,8 +507,6 @@ static int usbhs_omap_probe(struct platform_device *pdev)
return -EADDRNOTAVAIL;
}

- spin_lock_init(&omap->lock);
-
omap->pdata = pdata;

pm_runtime_enable(dev);
--
1.7.4.1