Re: [PATCH] thermal: step_wise: set throttle target within thermal instance limits

[Eduardo Valentin <eduardo.valentin@ti.com>]

On 10-04-2013 03:06, Zhang Rui wrote:
> On Tue, 2013-04-09 at 14:59 -0700, Andrew Bresticker wrote:
>> When selecting a target cooling state in get_target_state(), make sure
>> that the state is at least as high as the minimum when the temperature
>> is rising and at least as low as the maximum when the temperature is
>> falling.  This is necessary because, in the THREAML_TREND_RAISING and
>> THERMAL_TREND_DROPPING cases, the current state may only be incremented
>> or decremented by one even if it is outside the bounds of the thermal
>> instance.  This might occur, for example, if the CPU is heating up
>> and hits a thermal trip point for the first time when it's frequency
>> is much higher than the range specified by the thermal instance
>> corresponding to the trip point.
>>
>> Signed-off-by: Andrew Bresticker <abrestic@chromium.org>
>
> applied.

Rui,

Can you please add my:

Acked-by: Eduardo Valentin <eduardo.valentin@ti.com>


Thanks,
>
> thanks,
> rui
>> ---
>>   drivers/thermal/step_wise.c | 10 ++++++++--
>>   1 file changed, 8 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/thermal/step_wise.c b/drivers/thermal/step_wise.c
>> index 407cde3..ca4f79f 100644
>> --- a/drivers/thermal/step_wise.c
>> +++ b/drivers/thermal/step_wise.c
>> @@ -59,9 +59,12 @@ static unsigned long get_target_state(struct thermal_instance *instance,
>>
>>   	switch (trend) {
>>   	case THERMAL_TREND_RAISING:
>> -		if (throttle)
>> +		if (throttle) {
>>   			cur_state = cur_state < instance->upper ?
>>   				    (cur_state + 1) : instance->upper;
>> +			if (cur_state < instance->lower)
>> +				cur_state = instance->lower;
>> +		}
>>   		break;
>>   	case THERMAL_TREND_RAISE_FULL:
>>   		if (throttle)
>> @@ -71,8 +74,11 @@ static unsigned long get_target_state(struct thermal_instance *instance,
>>   		if (cur_state == instance->lower) {
>>   			if (!throttle)
>>   				cur_state = -1;
>> -		} else
>> +		} else {
>>   			cur_state -= 1;
>> +			if (cur_state > instance->upper)
>> +				cur_state = instance->upper;
>> +		}
>>   		break;
>>   	case THERMAL_TREND_DROP_FULL:
>>   		if (cur_state == instance->lower) {
>
>
>
>