Re: [PATCH 1/3] clk: xilinx: vcu: Update vcu init/reset sequence

[Stephen Boyd <sboyd@kernel.org>]

Quoting Rohit Visavalia (2024-12-26 04:20:21)
> diff --git a/drivers/clk/xilinx/xlnx_vcu.c b/drivers/clk/xilinx/xlnx_vcu.c
> index 81501b48412e..f294a2398cb4 100644
> --- a/drivers/clk/xilinx/xlnx_vcu.c
> +++ b/drivers/clk/xilinx/xlnx_vcu.c
> @@ -676,6 +679,24 @@ static int xvcu_probe(struct platform_device *pdev)
>          * Bit 0 : Gasket isolation
>          * Bit 1 : put VCU out of reset
>          */
> +       xvcu->reset_gpio = devm_gpiod_get_optional(&pdev->dev, "reset",
> +                                                  GPIOD_OUT_LOW);
> +       if (IS_ERR(xvcu->reset_gpio)) {
> +               ret = PTR_ERR(xvcu->reset_gpio);
> +               dev_err(&pdev->dev, "failed to get reset gpio for vcu.\n");

Use dev_err_probe() and friends.

> +               goto error_get_gpio;
> +       }
> +
> +       if (xvcu->reset_gpio) {
> +               gpiod_set_value(xvcu->reset_gpio, 0);
> +               /* min 2 clock cycle of vcu pll_ref, slowest freq is 33.33KHz */
> +               usleep_range(60, 120);
> +               gpiod_set_value(xvcu->reset_gpio, 1);
> +               usleep_range(60, 120);
> +       } else {
> +               dev_warn(&pdev->dev, "No reset gpio info from dts for vcu. This may lead to incorrect functionality if VCU isolation is removed post initialization.\n");

Is it 'vcu' or 'VCU'? Pick one please. Also, this is going to be an
unfixable warning message if the reset isn't there. Why have this
warning at all?