Re: [PATCH] extcon: palmas: Dont set USB state if ID pin is grounded

[Laxman Dewangan <ldewangan@nvidia.com>]

On Tuesday 10 September 2013 05:27 PM, George Cherian wrote:
> On 9/10/2013 2:47 PM, Laxman Dewangan wrote:
>> On Tuesday 10 September 2013 01:19 PM, George Cherian wrote:
>>> In OMAP5 when USB-HOST is set true, the VBUS regulator  is turned ON.
>>> This causes a VBUS interrupt, ignore the same if we are already in
>>> USB-HOST.
>>>
>>> Signed-off-by: George Cherian <george.cherian@ti.com>
>>> ---
>>>    drivers/extcon/extcon-palmas.c | 3 +++
>>>    1 file changed, 3 insertions(+)
>>>
>>> diff --git a/drivers/extcon/extcon-palmas.c
>>> b/drivers/extcon/extcon-palmas.c
>>> index 9672f31..91b31af 100644
>>> --- a/drivers/extcon/extcon-palmas.c
>>> +++ b/drivers/extcon/extcon-palmas.c
>>> @@ -50,6 +50,9 @@ static irqreturn_t palmas_vbus_irq_handler(int irq,
>>> void *_palmas_usb)
>>>        struct palmas_usb *palmas_usb = _palmas_usb;
>>>        unsigned int vbus_line_state;
>>>    +    if (palmas_usb->linkstat == PALMAS_USB_STATE_ID)
>>> +        return IRQ_HANDLED;
>>> +
>> Should we really handle this on this extcon driver? I think it should
>> be handled in the USB driver. If port is OTG type and if usb driver
>> enable the VBUS then it can expect the VBUS available notification but
>> based on the USB driver state, it should ignore this notification.
>>
> Correct extcon should just notify and the consumer should take
> appropriate decision.

Thanks, so our code design is same as yours and so we will not need this 
patch.


>> Otherwise, Palmas pin find that there is VBUS state true but the SW
>> status will show as the VBUS not there.
>>
>