Re: [PATCH v4] media: st-rc: Add ST remote control driver

[Stephen Warren <swarren@wwwdotorg.org>]

On 09/19/2013 02:59 AM, Srinivas KANDAGATLA wrote:
> This patch adds support to ST RC driver, which is basically a IR/UHF
> receiver and transmitter. This IP (IRB) is common across all the ST
> parts for settop box platforms. IRB is embedded in ST COMMS IP block.
> It supports both Rx & Tx functionality.
> 
> In this driver adds only Rx functionality via LIRC codec.

> diff --git a/Documentation/devicetree/bindings/media/st-rc.txt b/Documentation/devicetree/bindings/media/st-rc.txt

> +Required properties:
> +	- compatible: should contain "st,comms-irb".
> +	- reg: base physical address of the controller and length of memory
> +	mapped  region.

Nits:

The indentation is a little odd here; I'd expect the - to be in column
1, at least that's how most other binding docs are written. Not a big
deal though.

It'd be nice to indent the continuation lines (e.g. "mapped region") a
bit more so it's easier to see where each new entry starts.

There are two spaces in "mapped  region".

> +	- rx-mode: can be "infrared" or "uhf". rx-mode should be present iff the
> +	  rx pins are wired up.
> +	- tx-mode: should be "infrared". tx-mode should be present iff the tx
> +	  pins are wired up.

Should those property names be prefixed with "st,"; I assume they're
specific to this binding rather than something generic that applies to
all IR controller bindings? If you expect them to be generic, it's fine.

> +	- clocks : phandle with clock-specifier pair.

For what clock?