Re: [PATCH] phy: miphy365x: Select GENERIC_PHY rather than depends on

[Kishon Vijay Abraham I <kishon@ti.com>]

Hi,

On Thursday 11 September 2014 11:17 PM, Peter Griffin wrote:
> Change miphy365x over to select GENERIC_PHY like all other phy drivers.

A patch for this by Lee Jones has already been merged and should come up in
this -rc cycle.

Thanks
Kishon
> Also update the help message as the new stih410 SoC doesn't have this
> phy (it is very similar to sti407), so the stih41x naming is sadly no
> longer correct.
> 
> Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
> ---
>  drivers/phy/Kconfig | 6 +++---
>  1 file changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/phy/Kconfig b/drivers/phy/Kconfig
> index d361d98..68bfe07 100644
> --- a/drivers/phy/Kconfig
> +++ b/drivers/phy/Kconfig
> @@ -39,14 +39,14 @@ config PHY_MVEBU_SATA
>  	select GENERIC_PHY
>  
>  config PHY_MIPHY365X
> -	tristate "STMicroelectronics MIPHY365X PHY driver for STiH41x series"
> +	tristate "STMicroelectronics MIPHY365X PHY driver for STiH415/6 series"
>  	depends on ARCH_STI
> -	depends on GENERIC_PHY
>  	depends on HAS_IOMEM
>  	depends on OF
> +	select GENERIC_PHY
>  	help
>  	  Enable this to support the miphy transceiver (for SATA/PCIE)
> -	  that is part of STMicroelectronics STiH41x SoC series.
> +	  that is part of STMicroelectronics STiH415/6 SoC series.
>  
>  config OMAP_CONTROL_PHY
>  	tristate "OMAP CONTROL PHY Driver"
>