Re: [PATCH] pinctrl: baytrail: Clear DIRECT_IRQ bit

[Mathias Nyman <mathias.nyman@linux.intel.com>]

On 09/17/2014 03:30 PM, Loic Poulain wrote:
> Direct Irq En bit can be initialized to a bad value.
> This bit has to be cleared for io access mode.
> 
> Signed-off-by: Loic Poulain <loic.poulain@intel.com>
> ---
>  drivers/pinctrl/pinctrl-baytrail.c | 3 ++-
>  1 file changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/pinctrl/pinctrl-baytrail.c b/drivers/pinctrl/pinctrl-baytrail.c
> index 975572e..94902f7 100644
> --- a/drivers/pinctrl/pinctrl-baytrail.c
> +++ b/drivers/pinctrl/pinctrl-baytrail.c
> @@ -44,6 +44,7 @@
>  
>  /* BYT_CONF0_REG register bits */
>  #define BYT_IODEN		BIT(31)
> +#define BYT_DIRECT_IRQ		BIT(27)
>  #define BYT_TRIG_NEG		BIT(26)
>  #define BYT_TRIG_POS		BIT(25)
>  #define BYT_TRIG_LVL		BIT(24)
> @@ -232,7 +233,7 @@ static int byt_irq_type(struct irq_data *d, unsigned type)
>  	/* For level trigges the BYT_TRIG_POS and BYT_TRIG_NEG bits
>  	 * are used to indicate high and low level triggering
>  	 */
> -	value &= ~(BYT_TRIG_POS | BYT_TRIG_NEG | BYT_TRIG_LVL);
> +	value &= ~(BYT_DIRECT_IRQ | BYT_TRIG_POS | BYT_TRIG_NEG | BYT_TRIG_LVL);
>  
>  	switch (type) {
>  	case IRQ_TYPE_LEVEL_HIGH:
> 

Just checked that there is a patch already upstream that warns if this bit is set.
It defines BYT_DIRECT_IRQ_EN already, but doesn't clear the bit.

commit ff998356b644ebe723127bd9eec6040b59a4a4f6
Author: Eric Ernst <eric.ernst@linux.intel.com>
Date:   Thu Jun 12 11:06:20 2014 -0700

    pinctrl: baytrail: Warn if direct IRQ GPIO set to output


Maybe adding a patch clearing the bit on top of that patch?

And send that patch to Linus Walleij as well (added to cc) 

Thanks
-Mathias