Re: [PATCH v13 4/5] ARM: dts: add main Thermal info to rk3288

[Caesar Wang <caesar.wang@rock-chips.com>]

Dmitry,

在 2014/10/24 8:46, Dmitry Torokhov 写道:
> Hi Caesar,
>
> On Thu, Oct 23, 2014 at 05:40:06PM +0800, Caesar Wang wrote:
>> This patch is depend on rk3288-thermal.dtsi,or
>> it will compile error.
>>
>> If the temperature over a period of time High,over 120C
>> the resulting TSHUT gave CRU module,let it reset
>> the entire chip,or via GPIO give PMIC.
>>
>> Signed-off-by: Caesar Wang <caesar.wang@rock-chips.com>
>> ---
>>   arch/arm/boot/dts/rk3288.dtsi | 21 +++++++++++++++++++++
>>   1 file changed, 21 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/rk3288.dtsi b/arch/arm/boot/dts/rk3288.dtsi
>> index cb18bb4..85fc17a 100644
>> --- a/arch/arm/boot/dts/rk3288.dtsi
>> +++ b/arch/arm/boot/dts/rk3288.dtsi
>> @@ -15,6 +15,7 @@
>>   #include <dt-bindings/interrupt-controller/arm-gic.h>
>>   #include <dt-bindings/pinctrl/rockchip.h>
>>   #include <dt-bindings/clock/rk3288-cru.h>
>> +#include <dt-bindings/thermal/thermal.h>
>>   #include "skeleton.dtsi"
>>   
>>   / {
>> @@ -66,6 +67,7 @@
>>   				 216000  900000
>>   				 126000  900000
>>   			>;
>> +			#cooling-cells = <2>; /* min followed by max */
>>   			clock-latency = <40000>;
>>   			clocks = <&cru ARMCLK>;
>>   		};
>> @@ -346,6 +348,19 @@
>>   		status = "disabled";
>>   	};
>>   
>> +	tsadc: tsadc@ff280000 {
>> +		compatible = "rockchip,rk3288-tsadc";
>> +		reg = <0xff280000 0x100>;
>> +		interrupts = <GIC_SPI 37 IRQ_TYPE_LEVEL_HIGH>;
>> +		clocks = <&cru SCLK_TSADC>, <&cru PCLK_TSADC>;
>> +		clock-names = "tsadc", "apb_pclk";
>> +		pinctrl-names = "default";
>> +		pinctrl-0 = <&otp_out>;
>> +		#thermal-sensor-cells = <1>;
>> +		hw-shut-temp = <120000>;
> I do not think this is a good value. You have (in the other DTS file)
> passive trip point at 80 and critical (which should result in orderly
> shutdown) at 125. But here you define hardware-controlled shutdown at
> 120C, which is backwards. You should have:
>
> passive <= critical <= hardware
Hmmm....
but, the system will shutdown when temperature over critial value,
there is no chance of triggering the TSHUT.

If the temperature over a period of time High,as we know,
the resulting TSHUT gave CRU module,let it hot-reset the entire chip,
or via GPIO give PMIC cold-reset the entire chip.



> Thanks.
>

-- 
Best regards,
Caesar