Re: [5/5] i2c: davinci: use ICPFUNC to toggle I2C as gpio for bus recovery

[Grygorii Strashko <grygorii.strashko@ti.com>]

Hi Uwe,
On 11/24/2014 09:45 PM, Uwe Kleine-König wrote:
> On Mon, Nov 24, 2014 at 03:15:58PM +0200, Grygorii Strashko wrote:
>> On 11/23/2014 07:04 PM, Uwe Kleine-König wrote:
>>> On Thu, Nov 20, 2014 at 12:03:08PM +0200, Grygorii Strashko wrote:
>>>> @@ -664,6 +759,7 @@ static int davinci_i2c_probe(struct platform_device *pdev)
>>>>    		if (!of_property_read_u32(pdev->dev.of_node, "clock-frequency",
>>>>    			&prop))
>>>>    			dev->pdata->bus_freq = prop / 1000;
>>>> +		dev->pdata->has_pfunc = true;
>>> I don't understand this. Why does this ICPFUNC recovery work if the bus
>>> is probed by oftree, but doesn't if not?
>>
>> I've mentioned this in commit message:
>>   Allow platforms to indicate the presence of the ICPFUNC registers with a has_pfunc
>>   platform data flag and enable this mode for platforms which supports DT (da850 and
>>   Keystone 2 are two SoCs which support DT now and they also support ICPFUNC registers).
> Ah, so you assume that in the dt case the pfunc functionality is
> available. I didn't understand if it's bad or not if this assumption is
> wrong, but I suggest to only use the pfunc stuff if the device node has
> a given property (e.g. ti,has_pfunc).

Agree. I'll add it.

regards,
-grygorii