Re: [SCIS] mpt3sas: wait_for_completion_timeout timeout not reported

[Joe Lawrence <joe.lawrence@stratus.com>]

On 12/30/2014 11:19 AM, Nicholas Mc Guire wrote:
> wait_for_completion_timeout reaching timeout was being ignored,
> this also should fail if timeout condition occurs. 
> 
> Thanks to Joe Lawrence <joe.lawrence@stratus.com> for confirmation.

How about this instead:

Acked-by: Joe Lawrence <joe.lawrence@stratus.com>

You still probably want a review from the Avago folks though.

BTW, don't worry about the "[SCSI]" subject prefix to the commit,
"[PATCH]" is fine.  I believe the former is a convention that the
maintainer applies to patches as he collects them to indicate that they
originated via the SCSI tree.

Thanks,

-- Joe

> this was only compile tested with
> x86_64_defconfig + CONFIG_SCSI_LOWLEVEL=y + CONFIG_SCSI_MPT3SAS=m
> 
> patch is against linux-next 3.19.0-rc1 -next-20141226
> Signed-off-by: Nicholas Mc Guire <der.herr@hofr.at>
> ---
>  drivers/scsi/mpt3sas/mpt3sas_config.c |    2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/scsi/mpt3sas/mpt3sas_config.c b/drivers/scsi/mpt3sas/mpt3sas_config.c
> index 4472c2a..04ff21b 100644
> --- a/drivers/scsi/mpt3sas/mpt3sas_config.c
> +++ b/drivers/scsi/mpt3sas/mpt3sas_config.c
> @@ -393,7 +393,7 @@ _config_request(struct MPT3SAS_ADAPTER *ioc, Mpi2ConfigRequest_t
>  	mpt3sas_base_put_smid_default(ioc, smid);
>  	timeleft = wait_for_completion_timeout(&ioc->config_cmds.done,
>  	    timeout*HZ);
> -	if (!(ioc->config_cmds.status & MPT3_CMD_COMPLETE)) {
> +	if (timeleft == 0 || !(ioc->config_cmds.status & MPT3_CMD_COMPLETE)) {
>  		pr_err(MPT3SAS_FMT "%s: timeout\n",
>  		    ioc->name, __func__);
>  		_debug_dump_mf(mpi_request,
>