Re: [PATCH v2] gpio/xilinx: Use correct address when setting initial values.

Michal Simek
2015-06-25T08:50:34Z

On 06/24/2015 09:19 AM, Raphaël Teysseyre wrote:
> xgpio_save_regs() is used in this driver to setup the initial
> values of the registers in the hardware.
>
> The relevant registers at that time are:
> 0x0 -> channel 0 data (32 bits, one for each GPIO on this channel).
> 0x4 -> channel 0 tri, controls in/out status for each GPIO of this channel.
> 0x8 -> channel 1 data
> 0xC -> channel 1 tri
>
> gpio-xilinx.c defines these:
> XGPIO_DATA_OFFSET (0x0)
> XGPIO_TRI_OFFSET (0x4)
> XGPIO_CHANNEL_OFFSET 0x8
>
> Before this patch, the "data" register value of channel 1 was written
> at 0x4 intead of 0x8 (overwriting the channel 0 "tri" register),
> and the "tri" register value for channel 1 was written at 0x8 instead of 0xC.
>
> Signed-off-by: Raphaël Teysseyre <rteysseyre@gmail.com>
> ---
> drivers/gpio/gpio-xilinx.c | 4 ++--
> 1 files changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/gpio/gpio-xilinx.c b/drivers/gpio/gpio-xilinx.c
> index 61243d1..e544b7a 100644
> --- a/drivers/gpio/gpio-xilinx.c
> +++ b/drivers/gpio/gpio-xilinx.c
> @@ -220,9 +220,9 @@ static void xgpio_save_regs(struct of_mm_gpio_chip *mm_gc)
> if (!chip->gpio_width[1])
> return;
>
> - xgpio_writereg(mm_gc->regs + XGPIO_DATA_OFFSET + XGPIO_TRI_OFFSET,
> + xgpio_writereg(mm_gc->regs + XGPIO_DATA_OFFSET + XGPIO_CHANNEL_OFFSET,
> chip->gpio_state[1]);
> - xgpio_writereg(mm_gc->regs + XGPIO_TRI_OFFSET + XGPIO_TRI_OFFSET,
> + xgpio_writereg(mm_gc->regs + XGPIO_TRI_OFFSET + XGPIO_CHANNEL_OFFSET,
> chip->gpio_dir[1]);
> }

Reviewed-by: Michal Simek <michal.simek@xilinx.com>

Thanks,
Michal