[PATCHv2 1/2] mmc: block: ioctl: do write error check for spi

[Christian Loehle <CLoehle@hyperstone.com>]

SPI doesn't have the usual PROG path we can check for error bits
after moving back to TRAN. Instead it holds the line LOW until
completion. We can then check if the card shows any errors or
is in IDLE state, indicating the line is no longer LOW because
the card was reset.

Signed-off-by: Christian Loehle <cloehle@hyperstone.com>
---
 drivers/mmc/core/block.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/mmc/core/block.c b/drivers/mmc/core/block.c
index d920c4178389..e46330815484 100644
--- a/drivers/mmc/core/block.c
+++ b/drivers/mmc/core/block.c
@@ -178,6 +178,7 @@ static void mmc_blk_rw_rq_prep(struct mmc_queue_req *mqrq,
 			       int recovery_mode,
 			       struct mmc_queue *mq);
 static void mmc_blk_hsq_req_done(struct mmc_request *mrq);
+static int mmc_spi_err_check(struct mmc_card *card);
 
 static struct mmc_blk_data *mmc_blk_get(struct gendisk *disk)
 {
@@ -608,6 +609,11 @@ static int __mmc_blk_ioctl_cmd(struct mmc_card *card, struct mmc_blk_data *md,
 	if ((card->host->caps & MMC_CAP_WAIT_WHILE_BUSY) && use_r1b_resp)
 		return 0;
 
+	if (mmc_host_is_spi(card->host)) {
+		if (idata->ic.write_flag || r1b_resp || cmd.flags & MMC_RSP_SPI_BUSY)
+			return mmc_spi_err_check(card);
+		return err;
+	}
 	/* Ensure RPMB/R1B command has completed by polling with CMD13. */
 	if (idata->rpmb || r1b_resp)
 		err = mmc_poll_for_busy(card, busy_timeout_ms, false,
-- 
2.37.3


Hyperstone GmbH | Reichenaustr. 39a  | 78467 Konstanz
Managing Director: Dr. Jan Peter Berns.
Commercial register of local courts: Freiburg HRB381782