[PATCH v4 0/2] arm64: Add basic support for Marvell Berlin4CT SoC

Jisheng Zhang
2015-07-22T09:40:30Z

Marvell Berlin4CT is a SoC based on 64bit ARMv8 architecture. It contains
quad CA53 cores.

This SoC shares many HW IP with BG2Q and other berlin series. This patchset
was tested on Berlin4CT DMP board, and boot to shell ok.

Since v3:
- remove bootargs. follow the same behavior as other arm64 SoCs.

Since v2:
- remove the memreserve which isn't removed by mistake
- add earlycon to enable earlyconsole, inspired by Sudeep

Since v1:
- remove "earlyprintk" bootargs which doesn't work on arm64
- fix GICC_DIR size as pointed out by Mark
- define memory start address instead of memory reservation as suggested by Mark
- add interrupt-affinity to pmu node as pointed out by Sudeep

Jisheng Zhang (2):
arm64: dts: Add dts files for Marvell Berlin4CT SoC
arm64: Enable Marvell Berlin SoC family in Kconfig and defconfig

arch/arm64/Kconfig.platforms | 6 +
arch/arm64/boot/dts/Makefile | 1 +
arch/arm64/boot/dts/marvell/Makefile | 5 +
arch/arm64/boot/dts/marvell/berlin4ct-dmp.dts | 66 +++++++++++
arch/arm64/boot/dts/marvell/berlin4ct.dtsi | 164 ++++++++++++++++++++++++++
arch/arm64/configs/defconfig | 1 +
6 files changed, 243 insertions(+)
create mode 100644 arch/arm64/boot/dts/marvell/Makefile
create mode 100644 arch/arm64/boot/dts/marvell/berlin4ct-dmp.dts
create mode 100644 arch/arm64/boot/dts/marvell/berlin4ct.dtsi

--
2.1.4