From: Chanwoo Choi <cw00.choi@samsung.com>
To: Anand Moon <linux.amoon@gmail.com>
Cc: "MyungJoo Ham" <myungjoo.ham@gmail.com>,
"Kyungmin Park" <kyungmin.park@samsung.com>,
"Kukjin Kim" <kgene@kernel.org>,
"Krzysztof Kozłowski" <k.kozlowski@samsung.com>,
"Rob Herring" <robh+dt@kernel.org>,
"Pawel Moll" <pawel.moll@arm.com>,
"Mark Rutland" <mark.rutland@arm.com>,
"Ian Campbell" <ijc+devicetree@hellion.org.uk>,
"Kumar Gala" <galak@codeaurora.org>,
"Russell King" <linux@arm.linux.org.uk>,
"Tobias Jakobi" <tjakobi@math.uni-bielefeld.de>,
LKML <linux-kernel@vger.kernel.org>,
"Linux PM list" <linux-pm@vger.kernel.org>,
"Linux Samsung SoC" <linux-samsung-soc@vger.kernel.org>,
devicetree <devicetree@vger.kernel.org>
Subject: Re: [RFC PATCH 01/15] PM / devfreq: exynos: Add generic exynos bus frequency driver
Date: Fri, 27 Nov 2015 09:34:00 +0900 [thread overview]
Message-ID: <5657A4F8.4080003@samsung.com> (raw)
In-Reply-To: <CANAwSgQtvp_7hODvLz--5QmXMYqhOQYyBjihyRqWYv5HEk0u5A@mail.gmail.com>
Hi Anand,
On 2015년 11월 27일 02:17, Anand Moon wrote:
> Hi Chanwoo,
>
> On 26 November 2015 at 21:42, Chanwoo Choi <cwchoi00@gmail.com> wrote:
>> On Thu, Nov 26, 2015 at 11:00 PM, MyungJoo Ham <myungjoo.ham@samsung.com> wrote:
>>> On Thu, Nov 26, 2015 at 10:47 PM, Chanwoo Choi <cw00.choi@samsung.com> wrote:
>>>> This patch adds the generic exynos bus frequency driver for AMBA AXI bus
>>>> of sub-blocks in exynos SoC with DEVFREQ framework. The Samsung Exynos SoC
>>>> have the common architecture for bus between DRAM and sub-blocks in SoC.
>>>> This driver can support the generic bus frequency driver for Exynos SoCs.
>>>>
>>>> In devicetree, Each bus block has a bus clock, regulator, operation-point
>>>> and devfreq-event devices which measure the utilization of each bus block.
>>>>
>>>> Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
>>>> ---
>>>> drivers/devfreq/Kconfig | 15 ++
>>>> drivers/devfreq/Makefile | 1 +
>>>> drivers/devfreq/exynos/Makefile | 1 +
>>>> drivers/devfreq/exynos/exynos-bus.c | 443 ++++++++++++++++++++++++++++++++++++
>>>> 4 files changed, 460 insertions(+)
>>>> create mode 100644 drivers/devfreq/exynos/exynos-bus.c
>>>>
>>>
>>> Are we finally getting a common Exynos bus driver with full DT support?
>>> (can this replace both Exynos4/5 drivers and support Exynos7 series?)
>>
>> Yes.
>> This patch-set would support all Exynos SoCs for bus frequency driver.
>> To make sure the support for Exynos7 series, I need to check the TRM
>> document of Exynos7. I think it is possible for support Exynos7.
>>
>> I'm going to test this driver on various Exynos-based board.
>>
>> Regards,
>> Chanwoo Choi
>
> Please do consider Exynos 542x series as well.
Sure. I'll to test it on Exynos5422-based Odroid-XU3.
Regards,
Chanwoo Choi
next prev parent reply other threads:[~2015-11-27 0:34 UTC|newest]
Thread overview: 26+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-11-26 13:47 [RFC PATCH 00/15] PM / devferq: Add generic exynos bus frequency driver and new passive governor Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 01/15] PM / devfreq: exynos: Add generic exynos bus frequency driver Chanwoo Choi
2015-11-26 14:00 ` MyungJoo Ham
2015-11-26 16:12 ` Chanwoo Choi
2015-11-26 17:17 ` Anand Moon
2015-11-27 0:34 ` Chanwoo Choi [this message]
2015-12-09 4:11 ` Chanwoo Choi
2015-12-09 4:19 ` Anand Moon
2015-11-26 13:47 ` [RFC PATCH 02/15] PM / devfreq: exynos: Add documentation for " Chanwoo Choi
2015-11-27 20:30 ` Rob Herring
2015-11-28 2:13 ` Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 03/15] ARM: dts: Add DMC bus node for Exynos3250 Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 04/15] ARM: dts: Add DMC bus freqeuncy for exynos3250-rinato/monk Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 05/15] PM / devfreq: Add new passive governor Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 06/15] PM / devfreq: Add devfreq_get_devfreq_by_phandle() Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 07/15] PM / devfreq: Show the related information according to governor type Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 08/15] PM / devfreq: exynos: Add support of bus frequency of sub-blocks using passive governor Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 09/15] PM / devfreq: exynos: Update documentation for bus devices " Chanwoo Choi
2015-11-30 21:14 ` Rob Herring
2015-12-02 1:41 ` Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 10/15] PM / devfreq: exynos: Remove unused exynos4/5 busfreq driver Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 11/15] ARM: dts: Add bus nodes using VDD_INT for Exynos3250 Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 12/15] ARM: dts: Add support of bus frequency using VDD_INT for exynos3250-rinato Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 13/15] ARM: dts: Add bus nodes using VDD_MIF for Exynos4x12 Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 14/15] ARM: dts: Add bus nodes using VDD_INT " Chanwoo Choi
2015-11-26 13:47 ` [RFC PATCH 15/15] ARM: dts: Add support of bus frequency for exynos4412-trats Chanwoo Choi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=5657A4F8.4080003@samsung.com \
--to=cw00.choi@samsung.com \
--cc=devicetree@vger.kernel.org \
--cc=galak@codeaurora.org \
--cc=ijc+devicetree@hellion.org.uk \
--cc=k.kozlowski@samsung.com \
--cc=kgene@kernel.org \
--cc=kyungmin.park@samsung.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-pm@vger.kernel.org \
--cc=linux-samsung-soc@vger.kernel.org \
--cc=linux.amoon@gmail.com \
--cc=linux@arm.linux.org.uk \
--cc=mark.rutland@arm.com \
--cc=myungjoo.ham@gmail.com \
--cc=pawel.moll@arm.com \
--cc=robh+dt@kernel.org \
--cc=tjakobi@math.uni-bielefeld.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox