Re: [PATCH] serial: samsung: Reorder the sequence of clock control when call s3c24xx_serial_set_termios()

[Marek Szyprowski <m.szyprowski@samsung.com>]

Dear Chanwoo,

On 2016-03-25 01:10, Chanwoo Choi wrote:
> Hi Robert,
>
> I send following patch to fix the broken serial log of Exynos SoC.
> As I knew, you also knew this issue.
> If possible, could you review or test this patch?

Robert no longer works for Samsung, so I'm afraid that he won't be able 
to test
this patch.

> Best Regards,
> Chanwoo Choi
>
> On 2016년 03월 14일 09:41, Chanwoo Choi wrote:
>> This patch fixes the broken serial log when changing the clock source
>> of uart device. Before disabling the original clock source, this patch
>> enables the new clock source to protect the clock off state for a split second.
>>
>> Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
>> ---
>>   drivers/tty/serial/samsung.c | 4 ++--
>>   1 file changed, 2 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/tty/serial/samsung.c b/drivers/tty/serial/samsung.c
>> index d72cd736bdc6..80d59dbfebba 100644
>> --- a/drivers/tty/serial/samsung.c
>> +++ b/drivers/tty/serial/samsung.c
>> @@ -1265,13 +1265,13 @@ static void s3c24xx_serial_set_termios(struct uart_port *port,
>>   	if (ourport->baudclk != clk) {
>>   		s3c24xx_serial_setsource(port, clk_sel);
>>   
>> +		clk_prepare_enable(clk);
>> +

IMHO clk_prepare_enable() should be moved before 
s3c24xx_serial_setsource() to be
really sure that there will be no period of hw operating with disabled 
baud clock.
Could you check if it works for you?

>>   		if (!IS_ERR(ourport->baudclk)) {
>>   			clk_disable_unprepare(ourport->baudclk);
>>   			ourport->baudclk = ERR_PTR(-EINVAL);
>>   		}
>>   
>> -		clk_prepare_enable(clk);
>> -
>>   		ourport->baudclk = clk;
>>   		ourport->baudclk_rate = clk ? clk_get_rate(clk) : 0;
>>   	}

Best regards
-- 
Marek Szyprowski, PhD
Samsung R&D Institute Poland