Re: [PATCH] ARM64: boot: dts: Add regulators for Tegra210 Smaug

[Laxman Dewangan <ldewangan@nvidia.com>]

On Saturday 04 June 2016 01:52 AM, Rhyland Klein wrote:
> +
> +			max77620_default: pinmux@0 {
> +				pin_gpio {
> +					pins = "gpio0", "gpio1", "gpio2", "gpio5",
> +					       "gpio6", "gpio7";
gpio5 and gpio6 are already there in below nodes and hence it is not 
needed here.

> +					function = "gpio";
> +				};
> +
> +				/*
> +				 * GPIO3 is used to en_pp3300, and it is part of power
> +				 * sequence, So it must be sequenced up (automatically
> +				 * set by OTP) and down properly.
> +				 */
> +				pin_gpio3 {
> +					pins = "gpio3";
> +					function = "fps-out";
> +					drive-open-drain = <1>;
> +					maxim,active-fps-source = <MAX77620_FPS_SRC_0>;
> +					maxim,active-fps-power-up-slot = <4>;
> +					maxim,active-fps-power-down-slot = <2>;
> +				};
> +
> +				pin_gpio5_6_7 {
node name should be gpio5_6 as there is no gpio7 inside this node.


> +
> +			regulators {
> +				in-ldo0-1-supply = <&pp1350>;
> +				in-ldo2-supply = <&pp3300>;
> +				in-ldo3-5-supply = <&pp3300>;
> +				in-ldo7-8-supply = <&pp1350>;
> +
> +				ppvar_soc: sd0 {
> +					regulator-name = "PPVAR_SOC";
> +					regulator-min-microvolt = <825000>;
> +					regulator-max-microvolt = <1125000>;
> +					regulator-enable-ramp-delay = <146>;
> +					regulator-disable-ramp-delay = <4080>;
> +					regulator-ramp-delay = <27500>;
> +					regulator-ramp-delay-scale = <300>;

There is no disable-ramp-delay in mainline.
Please use the correct value for property as:
                                      regulator-ramp-delay = <9000>;
                                      maxim,ramp-rate-setting = <27500>;


instead of regulator-ramp-delay and regulator-ramp-delay-scale.
The property differs from downstream.

regulator-ramp-delay is what you see in platform and 
maxim,ramp-rate-setting is what you want in register.