Re: [PATCH 6/8] extcon: axp288: Use vbus-valid instead of -present to determine cable presence

[Chanwoo Choi <cw00.choi@samsung.com>]

Hi Hans,

On 2016년 12월 19일 09:13, Hans de Goede wrote:
> The vbus-present bit in the power status register also gets set to 1
> when a usb-host cable (id-pin shorted to ground) is plugged in and a 5v
> boost converter is supplying 5v to the otg usb bus.
> 
> This causes a "disconnect or unknown or ID event" warning in dmesg as
> well as the extcon device to report the last detected charger cable
> type as being connected even though none is connected.
> 
> This commit switches to checking the vbus-valid bit instead, which is
> only 1 when both vbus is present and the vbus-path is enabled in the
> vbus-path control register (the vbus-path gets disabled when a usb-host
> cable is detected, to avoid the pmic drawing power from the 5v boost
> converter).
> 
> Signed-off-by: Hans de Goede <hdegoede@redhat.com>
> ---
>  drivers/extcon/extcon-axp288.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/extcon/extcon-axp288.c b/drivers/extcon/extcon-axp288.c
> index fc636f6..7aec413 100644
> --- a/drivers/extcon/extcon-axp288.c
> +++ b/drivers/extcon/extcon-axp288.c
> @@ -166,7 +166,7 @@ static int axp288_handle_chrg_det_event(struct axp288_extcon_info *info)
>  		return ret;
>  	}
>  
> -	vbus_attach = (pwr_stat & PS_STAT_VBUS_PRESENT);
> +	vbus_attach = (pwr_stat & PS_STAT_VBUS_VALID);
>  	if (!vbus_attach) {
>  		dev_info(info->dev, "vbus/cable disconnected\n");
>  		goto no_vbus;
> 

Acked-by: Chanwoo Choi <cw00.choi@samsung.com>

-- 
Regards,
Chanwoo Choi