Re: [PATCH] extcon: Release locking when sending the notification of connector state

[Chanwoo Choi <cw00.choi@samsung.com>]

+ H. Nikolaus Schaller <hns@goldelico.com>

On 2018년 06월 14일 13:14, Chanwoo Choi wrote:
> Previously, extcon used the spinlock before calling the notifier_call_chain
> to prevent the scheduled out of task and to prevent the notification delay.
> When spinlock is locked for sending the notification, deadlock issue
> occured on the side of extcon consumer device. To fix this issue,
> extcon consumer device should always use the work. it is always not
> reasonable to use work.
> 
> To fix this issue on extcon consumer device, release locking when sending
> the notification of connector state.
> 
> Fixes: ab11af049f88 ("extcon: Add the synchronization extcon APIs to support the notification")
> Cc: stable@vger.kernel.org
> Cc: Roger Quadros <rogerq@ti.com>
> Cc: Kishon Vijay Abraham I <kishon@ti.com>
> Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
> ---
>  drivers/extcon/extcon.c | 3 ++-
>  1 file changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/extcon/extcon.c b/drivers/extcon/extcon.c
> index 8bff5fd18185..f75b08a45d4e 100644
> --- a/drivers/extcon/extcon.c
> +++ b/drivers/extcon/extcon.c
> @@ -433,8 +433,8 @@ int extcon_sync(struct extcon_dev *edev, unsigned int id)
>  		return index;
>  
>  	spin_lock_irqsave(&edev->lock, flags);
> -
>  	state = !!(edev->state & BIT(index));
> +	spin_unlock_irqrestore(&edev->lock, flags);
>  
>  	/*
>  	 * Call functions in a raw notifier chain for the specific one
> @@ -448,6 +448,7 @@ int extcon_sync(struct extcon_dev *edev, unsigned int id)
>  	 */
>  	raw_notifier_call_chain(&edev->nh_all, state, edev);
>  
> +	spin_lock_irqsave(&edev->lock, flags);
>  	/* This could be in interrupt handler */
>  	prop_buf = (char *)get_zeroed_page(GFP_ATOMIC);
>  	if (!prop_buf) {
> 


-- 
Best Regards,
Chanwoo Choi
Samsung Electronics