[PATCH v2 0/2] Fixes NULL pointer access in spi-mt65xx.c

[PATCH v2 0/2] Fixes NULL pointer access in spi-mt65xx.c

[Fei Shao]

Hi,

This series contains two patches for spi-mt65xx.c, both focusing on its
interrupt handler mtk_spi_interrupt().

The first patch is to fix a NULL pointer access in the interrupt
handler, which is first found on a MT8186 Chromebook device when the
system tries to establish host communication with its embedded
controller.

The second one is a decorative clean-up when I'm working on the first
patch, which simply renames a variable to better follow the rest of the
code.
I put this after the first fix because I think that will make
maintainers and users slightly easier to only backport the fix if
needed.

Looking forward to any feedback, thank you.

Regards,
Fei

Changes in v2:
- Restore a missing curly brace being dropped during rebase
- Fix a typo in commit message (trans, not xfer)

Fei Shao (2):
  spi: spi-mt65xx: Fix NULL pointer access in interrupt handler
  spi: spi-mt65xx: Rename a variable in interrupt handler

 drivers/spi/spi-mt65xx.c | 48 ++++++++++++++++++++--------------------
 1 file changed, 24 insertions(+), 24 deletions(-)

-- 
2.44.0.396.g6e790dbe36-goog

[PATCH v2 1/2] spi: spi-mt65xx: Fix NULL pointer access in interrupt handler

[Fei Shao]

The TX buffer in spi_transfer can be a NULL pointer, so the interrupt
handler may end up writing to the invalid memory and cause crashes.

Add a check to trans->tx_buf before using it.

Fixes: 1ce24864bff4 ("spi: mediatek: Only do dma for 4-byte aligned buffers")
Signed-off-by: Fei Shao <fshao@chromium.org>
---

Changes in v2:
- Restore a missing curly brace being dropped during rebase
- Fix a typo in commit message (trans, not xfer)

 drivers/spi/spi-mt65xx.c | 22 ++++++++++++----------
 1 file changed, 12 insertions(+), 10 deletions(-)

diff --git a/drivers/spi/spi-mt65xx.c b/drivers/spi/spi-mt65xx.c
index 8d4633b353ee..e4cb22fe0075 100644
--- a/drivers/spi/spi-mt65xx.c
+++ b/drivers/spi/spi-mt65xx.c
@@ -788,17 +788,19 @@ static irqreturn_t mtk_spi_interrupt(int irq, void *dev_id)
 		mdata->xfer_len = min(MTK_SPI_MAX_FIFO_SIZE, len);
 		mtk_spi_setup_packet(host);
 
-		cnt = mdata->xfer_len / 4;
-		iowrite32_rep(mdata->base + SPI_TX_DATA_REG,
-				trans->tx_buf + mdata->num_xfered, cnt);
+		if (trans->tx_buf) {
+			cnt = mdata->xfer_len / 4;
+			iowrite32_rep(mdata->base + SPI_TX_DATA_REG,
+					trans->tx_buf + mdata->num_xfered, cnt);
 
-		remainder = mdata->xfer_len % 4;
-		if (remainder > 0) {
-			reg_val = 0;
-			memcpy(&reg_val,
-				trans->tx_buf + (cnt * 4) + mdata->num_xfered,
-				remainder);
-			writel(reg_val, mdata->base + SPI_TX_DATA_REG);
+			remainder = mdata->xfer_len % 4;
+			if (remainder > 0) {
+				reg_val = 0;
+				memcpy(&reg_val,
+					trans->tx_buf + (cnt * 4) + mdata->num_xfered,
+					remainder);
+				writel(reg_val, mdata->base + SPI_TX_DATA_REG);
+			}
 		}
 
 		mtk_spi_enable_transfer(host);
-- 
2.44.0.396.g6e790dbe36-goog

Re: [PATCH v2 1/2] spi: spi-mt65xx: Fix NULL pointer access in interrupt handler

[AngeloGioacchino Del Regno]

Il 21/03/24 08:08, Fei Shao ha scritto:
> The TX buffer in spi_transfer can be a NULL pointer, so the interrupt
> handler may end up writing to the invalid memory and cause crashes.
> 
> Add a check to trans->tx_buf before using it.
> 
> Fixes: 1ce24864bff4 ("spi: mediatek: Only do dma for 4-byte aligned buffers")
> Signed-off-by: Fei Shao <fshao@chromium.org>

Honestly, the code in the !host->can_dma conditional is probably a good candidate
for just going into its own function, as it is effectively an alternative flow for
the ISR (fifo vs dma xceiv) but whatever, as long as it doesn't get any "longer",
it's still fine I guess.... so:

Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>

[PATCH v2 2/2] spi: spi-mt65xx: Rename a variable in interrupt handler

[Fei Shao]

All the spi_transfer variables in this file use the name "xfer" except
the one in mtk_spi_interrupt(). Align the naming for consistency and
easier searching.

While at it, reformat one memcpy() usage since the coding style allows
100 column lines today.

This commit has no functional change.

Signed-off-by: Fei Shao <fshao@chromium.org>
---

(no changes since v1)

 drivers/spi/spi-mt65xx.c | 32 +++++++++++++++-----------------
 1 file changed, 15 insertions(+), 17 deletions(-)

diff --git a/drivers/spi/spi-mt65xx.c b/drivers/spi/spi-mt65xx.c
index e4cb22fe0075..36c2f52cd6b8 100644
--- a/drivers/spi/spi-mt65xx.c
+++ b/drivers/spi/spi-mt65xx.c
@@ -748,7 +748,7 @@ static irqreturn_t mtk_spi_interrupt(int irq, void *dev_id)
 	u32 cmd, reg_val, cnt, remainder, len;
 	struct spi_controller *host = dev_id;
 	struct mtk_spi *mdata = spi_controller_get_devdata(host);
-	struct spi_transfer *trans = mdata->cur_transfer;
+	struct spi_transfer *xfer = mdata->cur_transfer;
 
 	reg_val = readl(mdata->base + SPI_STATUS0_REG);
 	if (reg_val & MTK_SPI_PAUSE_INT_STATUS)
@@ -762,42 +762,40 @@ static irqreturn_t mtk_spi_interrupt(int irq, void *dev_id)
 		return IRQ_HANDLED;
 	}
 
-	if (!host->can_dma(host, NULL, trans)) {
-		if (trans->rx_buf) {
+	if (!host->can_dma(host, NULL, xfer)) {
+		if (xfer->rx_buf) {
 			cnt = mdata->xfer_len / 4;
 			ioread32_rep(mdata->base + SPI_RX_DATA_REG,
-				     trans->rx_buf + mdata->num_xfered, cnt);
+				     xfer->rx_buf + mdata->num_xfered, cnt);
 			remainder = mdata->xfer_len % 4;
 			if (remainder > 0) {
 				reg_val = readl(mdata->base + SPI_RX_DATA_REG);
-				memcpy(trans->rx_buf +
-					mdata->num_xfered +
-					(cnt * 4),
+				memcpy(xfer->rx_buf + (cnt * 4) + mdata->num_xfered,
 					&reg_val,
 					remainder);
 			}
 		}
 
 		mdata->num_xfered += mdata->xfer_len;
-		if (mdata->num_xfered == trans->len) {
+		if (mdata->num_xfered == xfer->len) {
 			spi_finalize_current_transfer(host);
 			return IRQ_HANDLED;
 		}
 
-		len = trans->len - mdata->num_xfered;
+		len = xfer->len - mdata->num_xfered;
 		mdata->xfer_len = min(MTK_SPI_MAX_FIFO_SIZE, len);
 		mtk_spi_setup_packet(host);
 
-		if (trans->tx_buf) {
+		if (xfer->tx_buf) {
 			cnt = mdata->xfer_len / 4;
 			iowrite32_rep(mdata->base + SPI_TX_DATA_REG,
-					trans->tx_buf + mdata->num_xfered, cnt);
+					xfer->tx_buf + mdata->num_xfered, cnt);
 
 			remainder = mdata->xfer_len % 4;
 			if (remainder > 0) {
 				reg_val = 0;
 				memcpy(&reg_val,
-					trans->tx_buf + (cnt * 4) + mdata->num_xfered,
+					xfer->tx_buf + (cnt * 4) + mdata->num_xfered,
 					remainder);
 				writel(reg_val, mdata->base + SPI_TX_DATA_REG);
 			}
@@ -809,21 +807,21 @@ static irqreturn_t mtk_spi_interrupt(int irq, void *dev_id)
 	}
 
 	if (mdata->tx_sgl)
-		trans->tx_dma += mdata->xfer_len;
+		xfer->tx_dma += mdata->xfer_len;
 	if (mdata->rx_sgl)
-		trans->rx_dma += mdata->xfer_len;
+		xfer->rx_dma += mdata->xfer_len;
 
 	if (mdata->tx_sgl && (mdata->tx_sgl_len == 0)) {
 		mdata->tx_sgl = sg_next(mdata->tx_sgl);
 		if (mdata->tx_sgl) {
-			trans->tx_dma = sg_dma_address(mdata->tx_sgl);
+			xfer->tx_dma = sg_dma_address(mdata->tx_sgl);
 			mdata->tx_sgl_len = sg_dma_len(mdata->tx_sgl);
 		}
 	}
 	if (mdata->rx_sgl && (mdata->rx_sgl_len == 0)) {
 		mdata->rx_sgl = sg_next(mdata->rx_sgl);
 		if (mdata->rx_sgl) {
-			trans->rx_dma = sg_dma_address(mdata->rx_sgl);
+			xfer->rx_dma = sg_dma_address(mdata->rx_sgl);
 			mdata->rx_sgl_len = sg_dma_len(mdata->rx_sgl);
 		}
 	}
@@ -841,7 +839,7 @@ static irqreturn_t mtk_spi_interrupt(int irq, void *dev_id)
 
 	mtk_spi_update_mdata_len(host);
 	mtk_spi_setup_packet(host);
-	mtk_spi_setup_dma_addr(host, trans);
+	mtk_spi_setup_dma_addr(host, xfer);
 	mtk_spi_enable_transfer(host);
 
 	return IRQ_HANDLED;
-- 
2.44.0.396.g6e790dbe36-goog

Re: [PATCH v2 2/2] spi: spi-mt65xx: Rename a variable in interrupt handler

[AngeloGioacchino Del Regno]

Il 21/03/24 08:08, Fei Shao ha scritto:
> All the spi_transfer variables in this file use the name "xfer" except
> the one in mtk_spi_interrupt(). Align the naming for consistency and
> easier searching.
> 
> While at it, reformat one memcpy() usage since the coding style allows
> 100 column lines today.
> 
> This commit has no functional change.
> 
> Signed-off-by: Fei Shao <fshao@chromium.org>

Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>

Re: [PATCH v2 0/2] Fixes NULL pointer access in spi-mt65xx.c

[Mark Brown]

On Thu, 21 Mar 2024 15:08:56 +0800, Fei Shao wrote:
> This series contains two patches for spi-mt65xx.c, both focusing on its
> interrupt handler mtk_spi_interrupt().
> 
> The first patch is to fix a NULL pointer access in the interrupt
> handler, which is first found on a MT8186 Chromebook device when the
> system tries to establish host communication with its embedded
> controller.
> 
> [...]

Applied to

   https://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi.git for-next

Thanks!

[1/2] spi: spi-mt65xx: Fix NULL pointer access in interrupt handler
      commit: a20ad45008a7c82f1184dc6dee280096009ece55
[2/2] spi: spi-mt65xx: Rename a variable in interrupt handler
      (no commit info)

All being well this means that it will be integrated into the linux-next
tree (usually sometime in the next 24 hours) and sent to Linus during
the next merge window (or sooner if it is a bug fix), however if
problems are discovered then the patch may be dropped or reverted.

You may get further e-mails resulting from automated or manual testing
and review of the tree, please engage with people reporting problems and
send followup patches addressing any issues that are reported if needed.

If any updates are required or you are submitting further changes they
should be sent as incremental updates against current git, existing
patches will not be replaced.

Please add any relevant lists and maintainers to the CCs when replying
to this mail.

Thanks,
Mark