Re: [net-next PATCH v2 1/2] net: phy: aquantia: add firmware load support

[Christian Marangi <ansuelsmth@gmail.com>]

On Wed, Nov 01, 2023 at 02:01:33PM +0100, Heiner Kallweit wrote:
> On 01.11.2023 13:36, Christian Marangi wrote:
> > From: Robert Marko <robimarko@gmail.com>
> > 
> > Aquantia PHY-s require firmware to be loaded before they start operating.
> > It can be automatically loaded in case when there is a SPI-NOR connected
> > to Aquantia PHY-s or can be loaded from the host via MDIO.
> > 
> > This patch adds support for loading the firmware via MDIO as in most cases
> > there is no SPI-NOR being used to save on cost.
> > Firmware loading code itself is ported from mainline U-boot with cleanups.
> > 
> > The firmware has mixed values both in big and little endian.
> > PHY core itself is big-endian but it expects values to be in little-endian.
> > The firmware is little-endian but CRC-16 value for it is stored at the end
> > of firmware in big-endian.
> > 
> > It seems the PHY does the conversion internally from firmware that is
> > little-endian to the PHY that is big-endian on using the mailbox
> > but mailbox returns a big-endian CRC-16 to verify the written data
> > integrity.
> > 
> > Co-developed-by: Christian Marangi <ansuelsmth@gmail.com>
> > Signed-off-by: Robert Marko <robimarko@gmail.com>
> > Signed-off-by: Christian Marangi <ansuelsmth@gmail.com>
> > ---
> > Changes v2:
> > - Move out of RFC
> > - Address sanity check for offsets
> > - Add additional comments on firmware load check
> > - Fix some typo
> > - Capitalize CRC in comments
> > - Rename load_sysfs to load_fs
> > 
> 
> To make the driver better maintainable: can the firmware handling code
> be placed in a separate source code file, similar to what has been done
> for the hwmon part?
> If yes, then this could also be the right time to move the aquantia
> driver to an own subdirectory.
> 

Sure! Np for me just is it really worth it? hwmod is a bigger one but
this is really a few functions.

Anyway if requested, I will move in v3 the driver to a dedicated
directory and move the function to a separate file!

-- 
	Ansuel