Re: [PATCH 3/3] mcp23s08: add i2c support

[Peter Korsgaard <jacmet@sunsite.dk>]

>>>>> "Grant" == Grant Likely <grant.likely@secretlab.ca> writes:

 Grant> On Thu, Jul 14, 2011 at 09:59:28PM +0200, Peter Korsgaard wrote:
 >> Add i2c bindings for the mcp230xx devices. This is quite a lot simpler
 >> than the spi ones as there's no funky sub addressing done (one struct
 >> i2c_client per struct gpio_chip).
 >> 
 >> The mcp23s08_platform_data structure is reused for i2c, even though
 >> only a single mcp23s08_chip_info structure is needed.
 >> 
 >> To make the platform data bus independent, the setup/teardown prototypes
 >> are slightly changed, so the bus specific struct (spi_device / i2c_client)
 >> is passed as a void pointer instead.
 >> 
 >> There's no in-tree users of these callbacks.

 Grant> Why don't we just remove them then?  The notifier mechanism is more
 Grant> generic anyway.

Ok, will do.

 Grant> [...]
 >> @@ -537,9 +705,13 @@ static int __init mcp23s08_init(void)
 >> return ret;
 >> #endif /* CONFIG_SPI_MASTER */
 >> 
 >> +#ifdef CONFIG_I2C
 >> +	ret = i2c_add_driver(&mcp230xx_driver);
 >> +#endif /* CONFIG_I2C */
 >> +

 Grant> Need to unwind on failure to register, or put the i2c driver into a
 Grant> separate module so that each module gets it's own init/exit hooks.

Ok, will unwind.

Thanks for the quick review, will send an updated patch series shortly.

-- 
Bye, Peter Korsgaard