Re: [PATCH 1/2] arm64: dts: marvell: uDPU: rename the SFP GPIO properties

[Gregory CLEMENT <gregory.clement@bootlin.com>]

Robert Marko <robert.marko@sartura.hr> writes:

> Rename the GPIO related SFP properties to include the preffered -gpios
> suffix as defined in the SFP schema.
>
> This fixes the following warning:
> arch/arm64/boot/dts/marvell/armada-3720-eDPU.dtb: sfp-eth1: 'los-gpio', 'mod-def0-gpio', 'tx-disable-gpio', 'tx-fault-gpio' do not match any of the regexes: 'pinctrl-[0-9]+'
> from schema $id: http://devicetree.org/schemas/net/sff,sfp.yaml#
>

Applied on mvebu/dt64

Thanks,

Gregory
> Signed-off-by: Robert Marko <robert.marko@sartura.hr>
> ---
>  arch/arm64/boot/dts/marvell/armada-3720-uDPU.dtsi | 8 ++++----
>  1 file changed, 4 insertions(+), 4 deletions(-)
>
> diff --git a/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dtsi b/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dtsi
> index 3f79923376fb..3a9b6907185d 100644
> --- a/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dtsi
> +++ b/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dtsi
> @@ -61,10 +61,10 @@ led-alarm2 {
>  	sfp_eth1: sfp-eth1 {
>  		compatible = "sff,sfp";
>  		i2c-bus = <&i2c1>;
> -		los-gpio = <&gpiosb 7 GPIO_ACTIVE_HIGH>;
> -		mod-def0-gpio = <&gpiosb 8 GPIO_ACTIVE_LOW>;
> -		tx-disable-gpio = <&gpiosb 9 GPIO_ACTIVE_HIGH>;
> -		tx-fault-gpio = <&gpiosb 10 GPIO_ACTIVE_HIGH>;
> +		los-gpios = <&gpiosb 7 GPIO_ACTIVE_HIGH>;
> +		mod-def0-gpios = <&gpiosb 8 GPIO_ACTIVE_LOW>;
> +		tx-disable-gpios = <&gpiosb 9 GPIO_ACTIVE_HIGH>;
> +		tx-fault-gpios = <&gpiosb 10 GPIO_ACTIVE_HIGH>;
>  		maximum-power-milliwatt = <3000>;
>  	};
>  };
> -- 
> 2.41.0
>

-- 
Gregory Clement, Bootlin
Embedded Linux and Kernel engineering
http://bootlin.com