Re: [PATCH v12 2/3] memory: Add STM32 Octo Memory Manager driver

[Krzysztof Kozlowski <krzk@kernel.org>]

On 06/05/2025 09:52, Patrice Chotard wrote:
> Octo Memory Manager driver (OMM) manages:
>   - the muxing between 2 OSPI busses and 2 output ports.
>     There are 4 possible muxing configurations:
>       - direct mode (no multiplexing): OSPI1 output is on port 1 and OSPI2
>         output is on port 2
>       - OSPI1 and OSPI2 are multiplexed over the same output port 1
>       - swapped mode (no multiplexing), OSPI1 output is on port 2,
>         OSPI2 output is on port 1
>       - OSPI1 and OSPI2 are multiplexed over the same output port 2
>   - the split of the memory area shared between the 2 OSPI instances.
>   - chip select selection override.
>   - the time between 2 transactions in multiplexed mode.
>   - check firewall access.
> 
> Signed-off-by: Christophe Kerello <christophe.kerello@foss.st.com>
> Signed-off-by: Patrice Chotard <patrice.chotard@foss.st.com>
> ---
>  drivers/memory/Kconfig     |  18 ++
>  drivers/memory/Makefile    |   1 +
>  drivers/memory/stm32_omm.c | 476 +++++++++++++++++++++++++++++++++++++++++++++
>  3 files changed, 495 insertions(+)
> 
> diff --git a/drivers/memory/Kconfig b/drivers/memory/Kconfig
> index c82d8d8a16eaf154c247c0dbb9aff428b7c81402..bc7ab46bd8b98a89f0d9173e884a99b778cdc9c4 100644
> --- a/drivers/memory/Kconfig
> +++ b/drivers/memory/Kconfig
> @@ -225,6 +225,24 @@ config STM32_FMC2_EBI
>  	  devices (like SRAM, ethernet adapters, FPGAs, LCD displays, ...) on
>  	  SOCs containing the FMC2 External Bus Interface.
>  
> +config STM32_OMM
> +	tristate "STM32 Octo Memory Manager"
> +	depends on ARCH_STM32 || COMPILE_TEST
> +	depends on SPI_STM32_OSPI

I don't think you tested for the reported issue. I reported that
firewall symbols are missing and you add dependency on ospi. How is that
related? How does this solve any problem?

And to be sure, I applied this and obviously - as expected - same errors.

Best regards,
Krzysztof