From: "Heiko Stübner" <heiko@sntech.de>
To: linux-mmc@vger.kernel.org, Mikko Rapeli <mikko.rapeli@linaro.org>
Cc: ulf.hansson@linaro.org, linux-kernel@vger.kernel.org,
adrian.hunter@intel.com, victor.shih@genesyslogic.com.tw,
ben.chuang@genesyslogic.com.tw, geert+renesas@glider.be,
angelogioacchino.delregno@collabora.com, dlan@gentoo.org,
arnd@arndb.de, zhoubinbin@loongson.cn,
Mikko Rapeli <mikko.rapeli@linaro.org>
Subject: Re: [PATCH v3 1/4] pmdomain: rockchip: enable ROCKCHIP_PM_DOMAINS with ARCH_ROCKCHIP
Date: Fri, 12 Sep 2025 17:00:10 +0200 [thread overview]
Message-ID: <9157586.VV5PYv0bhD@diego> (raw)
In-Reply-To: <20250912142253.2843018-2-mikko.rapeli@linaro.org>
Am Freitag, 12. September 2025, 16:22:50 Mitteleuropäische Sommerzeit schrieb Mikko Rapeli:
> On rk3399 based rockpi4b, mounting rootfs from mmc fails unless
> ROCKCHIP_PM_DOMAINS is enabled. Accoriding to
> Heiko Stübner <heiko@sntech.de> all SoCs since 2012 have power
> domains so the support should be enabled by default
> on both arm and arm64.
>
> Failing boot without CONFIG_ROCKCHIP_PM_DOMAINS=y:
>
> https://ledge.validation.linaro.org/scheduler/job/119268
>
> /dev/disk/by-partuuid/1d48ffd8-f2a7-4a33-b52f-186089b3c85e: Can't lookup blockdev
> /dev/disk/by-partuuid/1d48ffd8-f2a7-4a33-b52f-186089b3c85e: Can't lookup blockdev
> /dev/disk/by-partuuid/1d48ffd8-f2a7-4a33-b52f-186089b3c85e: Can't lookup blockdev
> /dev/disk/by-partuuid/1d48ffd8-f2a7-4a33-b52f-186089b3c85e: Can't lookup blockdev
> /dev/disk/by-partuuid/1d48ffd8-f2a7-4a33-b52f-186089b3c85e: Can't lookup blockdev
> /dev/disk/by-partuuid/1d48ffd8-f2a7-4a33-b52f-186089b3c85e: Can't lookup blockdev
> dw-apb-uart ff1a0000.serial: forbid DMA for kernel console
> root '/dev/disk/by-partuuid/1d48ffd8-f2a7-4a33-b52f-186089b3c85e' doesn't exist or does not contain a /dev.
> rk_gmac-dwmac fe300000.ethernet: deferred probe timeout, ignoring dependency
> rk_gmac-dwmac fe300000.ethernet: probe with driver rk_gmac-dwmac failed with error -110
> rk_iommu ff650800.iommu: deferred probe timeout, ignoring dependency
> rk_iommu ff650800.iommu: probe with driver rk_iommu failed with error -110
> dwmmc_rockchip fe320000.mmc: deferred probe timeout, ignoring dependency
> rockchip-typec-phy ff7c0000.phy: deferred probe timeout, ignoring dependency
> dwmmc_rockchip fe320000.mmc: probe with driver dwmmc_rockchip failed with error -110
> rockchip-typec-phy ff7c0000.phy: probe with driver rockchip-typec-phy failed with error -110
> rockchip-typec-phy ff800000.phy: deferred probe timeout, ignoring dependency
> rockchip-typec-phy ff800000.phy: probe with driver rockchip-typec-phy failed with error -110
> rk_iommu ff660480.iommu: deferred probe timeout, ignoring dependency
> rk_iommu ff660480.iommu: probe with driver rk_iommu failed with error -110
> rk_iommu ff8f3f00.iommu: deferred probe timeout, ignoring dependency
> rk_iommu ff8f3f00.iommu: probe with driver rk_iommu failed with error -110
> rk_iommu ff903f00.iommu: deferred probe timeout, ignoring dependency
> rk_iommu ff903f00.iommu: probe with driver rk_iommu failed with error -110
> rk_iommu ff914000.iommu: deferred probe timeout, ignoring dependency
> rk_iommu ff914000.iommu: probe with driver rk_iommu failed with error -110
> rk_iommu ff924000.iommu: deferred probe timeout, ignoring dependency
> rk_iommu ff924000.iommu: probe with driver rk_iommu failed with error -110
> platform fe800000.usb: deferred probe pending: platform: wait for supplier /phy@ff7c0000/usb3-port
> sdhci-arasan fe330000.mmc: deferred probe timeout, ignoring dependency
> platform fe900000.usb: deferred probe pending: platform: wait for supplier /phy@ff800000/usb3-port
> sdhci-arasan fe330000.mmc: probe with driver sdhci-arasan failed with error -110
> platform ff1d0000.spi: deferred probe pending: (reason unknown)
> platform hdmi-sound: deferred probe pending: asoc-simple-card: parse error
>
> Working boot with CONFIG_ROCKCHIP_PM_DOMAINS=y:
>
> https://ledge.validation.linaro.org/scheduler/job/119272
>
> dwmmc_rockchip fe320000.mmc: IDMAC supports 32-bit address mode.
> dwmmc_rockchip fe320000.mmc: Using internal DMA controller.
> dwmmc_rockchip fe320000.mmc: Version ID is 270a
> dwmmc_rockchip fe320000.mmc: DW MMC controller at irq 45,32 bit host data width,256 deep fifo
> dwmmc_rockchip fe320000.mmc: Got CD GPIO
> ff1a0000.serial: ttyS2 at MMIO 0xff1a0000 (irq = 44, base_baud = 1500000) is a 16550A
> printk: legacy console [ttyS2] enabled
> mmc_host mmc1: Bus speed (slot 0) = 400000Hz (slot req 400000Hz, actual 400000HZ div = 0)
> dw_wdt ff848000.watchdog: No valid TOPs array specified
> mmc_host mmc1: Bus speed (slot 0) = 50000000Hz (slot req 50000000Hz, actual 50000000HZ div = 0)
> mmc0: CQHCI version 5.10
> rk_gmac-dwmac fe300000.ethernet: IRQ eth_wake_irq not found
> mmc1: new high speed SDHC card at address aaaa
> fan53555-regulator 0-0040: FAN53555 Option[8] Rev[1] Detected!
> fan53555-regulator 0-0041: FAN53555 Option[8] Rev[1] Detected!
> rk_gmac-dwmac fe300000.ethernet: IRQ eth_lpi not found
> mmcblk1: mmc1:aaaa SC16G 14.8 GiB
> rk_gmac-dwmac fe300000.ethernet: IRQ sfty not found
> GPT:Primary header thinks Alt. header is not at the end of the disk.
> rk_gmac-dwmac fe300000.ethernet: Deprecated MDIO bus assumption used
> GPT:1978417 != 31116287
> rk_gmac-dwmac fe300000.ethernet: PTP uses main clock
> GPT:Alternate GPT header not at the end of the disk.
> rk_gmac-dwmac fe300000.ethernet: clock input or output? (input).
> GPT:1978417 != 31116287
> rk_gmac-dwmac fe300000.ethernet: TX delay(0x28).
> GPT: Use GNU Parted to correct GPT errors.
> rk_gmac-dwmac fe300000.ethernet: RX delay(0x11).
> mmcblk1: p1 p2 p3 p4 p5 p6 p7 p8
>
> Suggested-by: Ulf Hansson <ulf.hansson@linaro.org>
> Suggested-by: Heiko Stübner <heiko@sntech.de>
> Suggested-by: Arnd Bergmann <arnd@arndb.de>
> Signed-off-by: Mikko Rapeli <mikko.rapeli@linaro.org>
> ---
> drivers/pmdomain/rockchip/Kconfig | 1 +
> 1 file changed, 1 insertion(+)
>
> diff --git a/drivers/pmdomain/rockchip/Kconfig b/drivers/pmdomain/rockchip/Kconfig
> index 218d43186e5b9..17f2e6fe86b6f 100644
> --- a/drivers/pmdomain/rockchip/Kconfig
> +++ b/drivers/pmdomain/rockchip/Kconfig
> @@ -3,6 +3,7 @@ if ARCH_ROCKCHIP || COMPILE_TEST
>
> config ROCKCHIP_PM_DOMAINS
> bool "Rockchip generic power domain"
> + default ARCH_ROCKCHIP
> depends on PM
> depends on HAVE_ARM_SMCCC_DISCOVERY
> depends on REGULATOR
>
Acked-by: Heiko Stuebner <heiko@sntech.de>
next prev parent reply other threads:[~2025-09-12 15:00 UTC|newest]
Thread overview: 14+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-09-12 14:30 [PATCH v3 4/4] ARM: rockchip: remove REGULATOR conditional to PM Mikko Rapeli
2025-09-12 14:27 ` [PATCH v3 1/4] pmdomain: rockchip: enable ROCKCHIP_PM_DOMAINS with ARCH_ROCKCHIP Mikko Rapeli
2025-09-12 14:22 ` [PATCH v3 0/4] enable ROCKCHIP_PM_DOMAINS Mikko Rapeli
2025-09-12 14:22 ` [PATCH v3 1/4] pmdomain: rockchip: enable ROCKCHIP_PM_DOMAINS with ARCH_ROCKCHIP Mikko Rapeli
2025-09-12 14:53 ` Arnd Bergmann
2025-09-12 15:00 ` Heiko Stübner [this message]
2025-09-12 14:22 ` [PATCH v3 2/4] mmc: add COMPILE_TEST to multiple drivers Mikko Rapeli
2025-09-12 14:53 ` Arnd Bergmann
2025-09-12 14:22 ` [PATCH v3 3/4] mmc: remove COMPILE_TEST from MMC_LOONGSON2 Mikko Rapeli
2025-09-12 14:50 ` Arnd Bergmann
2025-09-15 7:01 ` Mikko Rapeli
2025-09-13 4:58 ` Binbin Zhou
2025-09-12 14:22 ` [PATCH v3 4/4] ARM: rockchip: remove REGULATOR conditional to PM Mikko Rapeli
2025-09-12 14:36 ` [PATCH v3 0/4] enable ROCKCHIP_PM_DOMAINS Mikko Rapeli
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=9157586.VV5PYv0bhD@diego \
--to=heiko@sntech.de \
--cc=adrian.hunter@intel.com \
--cc=angelogioacchino.delregno@collabora.com \
--cc=arnd@arndb.de \
--cc=ben.chuang@genesyslogic.com.tw \
--cc=dlan@gentoo.org \
--cc=geert+renesas@glider.be \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mmc@vger.kernel.org \
--cc=mikko.rapeli@linaro.org \
--cc=ulf.hansson@linaro.org \
--cc=victor.shih@genesyslogic.com.tw \
--cc=zhoubinbin@loongson.cn \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox