From: ksardem@linux01.gwdg.de
To: linux-kernel@vger.kernel.org
Subject: bug in via-rhine network-driver (transmit timed out)
Date: Sun, 17 Nov 2002 08:59:45 +0100 [thread overview]
Message-ID: <981227431.20021117085945@linux01.gwdg.de> (raw)
Hi,
my Linux-PC (Kernel 2.4.19, SuSE 8.1)
has two PCI D-LINK DFE530-TX network card (10/100mbit) using driver via-rhine.o
Sometimes one or both of the interfaces (eth0/eth1) "time out", which means I
cannot send or transmit any more packets on this interface.
When I do a 'dmesg' I get these error-messages:
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Transmit timed out, status 0000, PHY status 782d, resetting...
eth0: reset did not complete in 10 ms.
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Transmit timed out, status 0000, PHY status 782d, resetting...
eth0: reset did not complete in 10 ms.
eth0: Setting half-duplex based on MII #8 link partner capability of 0021.
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Transmit timed out, status 0000, PHY status 782d, resetting...
eth0: reset did not complete in 10 ms.
...and so on
or:
NETDEV WATCHDOG: eth1: transmit timed out
eth1: Transmit timed out, status 0000, PHY status 782d, resetting...
eth1: reset did not complete in 10 ms.
NETDEV WATCHDOG: eth1: transmit timed out
eth1: Transmit timed out, status 0000, PHY status 782d, resetting...
eth1: reset did not complete in 10 ms.
...
I had the same problem with the D-LINK DFE-530TX-cards some time ago
with earlier releases of the 2.4.x-Kernel.
If I do a 'ifconfig eth0/eth1 down', 'rmmod via-rhine' and then
again 'modprove via-rhine' and 'ifconfig up...' it works again but
this is no real solution - I think it's a bug in the driver, isn't it?
This is my version of the via-rhine module:
V_NAME "via-rhine"
DRV_VERSION "1.1.14"
DRV_RELDATE "May-3-2002"
Here are some informations about my system which may be helpful:
/proc/modules:
via-rhine 13612 2
mii 1232 0 [via-rhine]
/proc/version:
Linux version 2.4.19-my (root@geeko) (gcc version 3.2)
/proc/cpuinfo:
processor : 0
vendor_id : GenuineIntel
cpu family : 6
model : 5
model name : Pentium II (Deschutes)
stepping : 2
cpu MHz : 349.968
cache size : 512 KB
/proc/ioports:
e400-e4ff : PCI device 1106:3065
e400-e4ff : via-rhine
e800-e8ff : PCI device 1106:3065
e800-e8ff : via-rhine
f000-f00f : PCI device 8086:7111
/proc/iomem:
e2000000-e20000ff : PCI device 1106:3065
e2000000-e20000ff : via-rhine
e2001000-e20010ff : PCI device 1106:3065
e2001000-e20010ff : via-rhine
lspci -vvv:
00:09.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 43)
Subsystem: D-Link System Inc DFE-530TX rev A
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Step
ping- SERR- FastB2B-Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort
- <MAbort- >SERR- <PERR-
Latency: 64 (750ns min, 2000ns max), cache line size 08
Interrupt: pin A routed to IRQ 9
Region 0: I/O ports at e400 [size=256]
Region 1: Memory at e2001000 (32-bit, non-prefetchable) [size=256]
Expansion ROM at e0000000 [disabled] [size=64K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot
-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
00:0a.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 43)
Subsystem: D-Link System Inc DFE-530TX rev A
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Step
ping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort
- <MAbort- >SERR- <PERR-
Latency: 64 (750ns min, 2000ns max), cache line size 08
Interrupt: pin A routed to IRQ 9
Region 0: I/O ports at e800 [size=256]
Region 1: Memory at e2000000 (32-bit, non-prefetchable) [size=256]
Expansion ROM at e1000000 [disabled] [size=64K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot
-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
01:00.0
Thanks for any help.
Bye.
next reply other threads:[~2002-11-17 7:50 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2002-11-17 7:59 ksardem [this message]
-- strict thread matches above, loose matches on Subject: below --
2002-11-17 8:30 bug in via-rhine network-driver (transmit timed out) Justin A
2002-11-17 9:37 Manfred Spraul
2002-12-09 16:54 ksardem
2002-12-09 16:58 ` Jeff Garzik
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=981227431.20021117085945@linux01.gwdg.de \
--to=ksardem@linux01.gwdg.de \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox