Re: [PATCH 4/5] scsi/ufs: qcom: Set phy mode based on the controllers HS MODE

[Subhash Jadavani <subhashj@codeaurora.org>]

On 2017-08-03 23:48, Vivek Gautam wrote:
> Set the phy mode based on the UFS HS PA mode. This lets the
> controller let phy know the mode in which the PHY Adapter is
> running and set the phy rates accordingly.
> 
> Signed-off-by: Vivek Gautam <vivek.gautam@codeaurora.org>
> ---
>  drivers/scsi/ufs/ufs-qcom.c | 3 +++
>  1 file changed, 3 insertions(+)
> 
> diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
> index c87d770b519a..44c21d5818ee 100644
> --- a/drivers/scsi/ufs/ufs-qcom.c
> +++ b/drivers/scsi/ufs/ufs-qcom.c
> @@ -273,6 +273,9 @@ static int ufs_qcom_power_up_sequence(struct 
> ufs_hba *hba)
>  	bool is_rate_B = (UFS_QCOM_LIMIT_HS_RATE == PA_HS_MODE_B)
>  							? true : false;
> 
> +	if (is_rate_B)
> +		phy_set_mode(phy, PHY_MODE_UFS_HS_B);
> +
>  	/* Assert PHY reset and apply PHY calibration values */
>  	ufs_qcom_assert_reset(hba);
>  	/* provide 1ms delay to let the reset pulse propagate */

Looks good to me.
Reviewed-by: Subhash Jadavani <subhashj@codeaurora.org>

-- 
The Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project