From: Paul Blazejowski <diffie@gmail.com>
To: Andrew Morton <akpm@osdl.org>
Cc: LKML <linux-kernel@vger.kernel.org>
Subject: Re: 2.6.9-rc1-mm4
Date: Thu, 9 Sep 2004 00:42:13 -0400 [thread overview]
Message-ID: <9dda3492040908214277f3d454@mail.gmail.com> (raw)
Andrew,
IT8212 driver fails to recognize RAID0 setup. The driver is built in
as module (it8212).
The drives are WDC 120gigers on primary channel as master/slave
configured for RAID0.
>From dmesg:
IT8212: IDE controller at PCI slot 0000:01:0c.0
ACPI: PCI Interrupt Link [APC2] enabled at IRQ 17
ACPI: PCI interrupt 0000:01:0c.0[A] -> GSI 17 (level, high) -> IRQ 17
IT8212: chipset revision 16
IT8212: 100% native mode on irq 17
ide2: BM-DMA at 0x9800-0x9807, BIOS settings: hde:DMA, hdf:pio
it8212: controller in RAID mode.
ide3: BM-DMA at 0x9808-0x980f, BIOS settings: hdg:pio, hdh:pio
Probing IDE interface ide2...
hde: Integrated Technology Express Inc, ATA DISK drive
ide2 at 0x8810-0x8817,0x8c02 on irq 17
hde: max request size: 128KiB
hde: 0 sectors (0 MB), CHS=0/0/0
hde: cache flushes not supported
hde: INVALID GEOMETRY: 0 PHYSICAL HEADS?
Probing IDE interface ide3...
lsmod shows:
it8212 6336 0 [permanent]
lspci -v:
01:0c.0 RAID bus controller: Integrated Technology Express, Inc.
IT/ITE8212 Dual channel ATA RAID controller (PCI version seems to be
IT8212, embedded seems (rev 10)
Subsystem: Integrated Technology Express, Inc.: Unknown device 0001
Flags: bus master, 66Mhz, medium devsel, latency 0, IRQ 17
I/O ports at 8810 [size=8]
I/O ports at 8c00 [size=4]
I/O ports at 9010 [size=8]
I/O ports at 9400 [size=4]
I/O ports at 9800 [size=16]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [80] Power Management version 2
The board is Gigabyte GA-7NNXP.
Under mm3 kernel, RAID0 was working when using the now dropped iteraid driver.
Paul
--
FreeBSD the Power to Serve!
next reply other threads:[~2004-09-09 4:42 UTC|newest]
Thread overview: 36+ messages / expand[flat|nested] mbox.gz Atom feed top
2004-09-09 4:42 Paul Blazejowski [this message]
2004-09-09 4:44 ` 2.6.9-rc1-mm4 Andrew Morton
2004-09-09 13:37 ` 2.6.9-rc1-mm4 Alan Cox
-- strict thread matches above, loose matches on Subject: below --
2004-09-08 15:43 2.6.9-rc1-mm4 Sid Boyce
2004-09-08 7:29 2.6.9-rc1-mm4 Sid Boyce
2004-09-07 16:45 2.6.9-rc1-mm4 Martin J. Bligh
2004-09-07 20:13 ` 2.6.9-rc1-mm4 Sam Ravnborg
2004-09-07 21:17 ` 2.6.9-rc1-mm4 Andrew Morton
2004-09-09 14:27 ` 2.6.9-rc1-mm4 Martin J. Bligh
2004-09-09 17:57 ` 2.6.9-rc1-mm4 Nick Piggin
2004-09-07 21:29 ` 2.6.9-rc1-mm4 Sam Ravnborg
2004-09-07 9:08 2.6.9-rc1-mm4 Andrew Morton
2004-09-07 11:59 ` 2.6.9-rc1-mm4 Terje Kvernes
2004-09-07 14:24 ` 2.6.9-rc1-mm4 Kasper Sandberg
2004-09-07 14:32 ` 2.6.9-rc1-mm4 Terje Kvernes
2004-09-07 17:04 ` 2.6.9-rc1-mm4 Francois Romieu
2004-09-07 18:30 ` 2.6.9-rc1-mm4 Terje Kvernes
2004-09-07 12:05 ` 2.6.9-rc1-mm4 Terje Kvernes
2004-09-07 12:21 ` 2.6.9-rc1-mm4 Simon Derr
2004-09-08 8:47 ` 2.6.9-rc1-mm4 Andrew Morton
2004-09-08 8:54 ` 2.6.9-rc1-mm4 Simon Derr
2004-09-08 9:37 ` 2.6.9-rc1-mm4 David Howells
2004-09-07 14:31 ` 2.6.9-rc1-mm4 Norberto Bensa
2004-09-07 15:45 ` 2.6.9-rc1-mm4 Zwane Mwaikambo
2004-09-07 16:46 ` 2.6.9-rc1-mm4 Danny ter Haar
2004-09-07 20:01 ` 2.6.9-rc1-mm4 Lorenzo Allegrucci
2004-09-07 20:23 ` 2.6.9-rc1-mm4 Nathan Bryant
2004-09-07 21:07 ` 2.6.9-rc1-mm4 Bjorn Helgaas
2004-09-08 8:15 ` 2.6.9-rc1-mm4 Lorenzo Allegrucci
2004-09-08 13:00 ` 2.6.9-rc1-mm4 William Lee Irwin III
2004-09-08 13:10 ` 2.6.9-rc1-mm4 David Howells
2004-09-08 20:16 ` 2.6.9-rc1-mm4 Nathan Lynch
2004-09-09 2:01 ` 2.6.9-rc1-mm4 William Lee Irwin III
2004-09-09 2:30 ` 2.6.9-rc1-mm4 William Lee Irwin III
2004-09-09 18:04 ` 2.6.9-rc1-mm4 Pasi Savolainen
2004-09-09 19:33 ` 2.6.9-rc1-mm4 Pasi Savolainen
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=9dda3492040908214277f3d454@mail.gmail.com \
--to=diffie@gmail.com \
--cc=akpm@osdl.org \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox