Re: [PATCH] KVM: x86: hyper-v: Don't auto-enable stimer during deserialization

[Nicolas Saenz Julienne <nsaenz@amazon.com>]

Hi Vitaly,

On Mon Oct 16, 2023 at 12:14 PM UTC, Vitaly Kuznetsov wrote:
> Nicolas Saenz Julienne <nsaenz@amazon.com> writes:
>
> > By not honoring the 'stimer->config.enable' state during stimer
> > deserialization we might introduce spurious timer interrupts. For
> > example through the following events:
> >  - The stimer is configured in auto-enable mode.
> >  - The stimer's count is set and the timer enabled.
> >  - The stimer expires, an interrupt is injected.
> >  - We live migrate the VM.
> >  - The stimer config and count are deserialized, auto-enable is ON, the
> >    stimer is re-enabled.
> >  - The stimer expires right away, and injects an unwarranted interrupt.
> >
> > So let's not change the stimer's enable state if the MSR write comes
> > from user-space.
> >
> > Fixes: 1f4b34f825e8 ("kvm/x86: Hyper-V SynIC timers")
> > Signed-off-by: Nicolas Saenz Julienne <nsaenz@amazon.com>
> > ---
> >  arch/x86/kvm/hyperv.c | 2 +-
> >  1 file changed, 1 insertion(+), 1 deletion(-)
> >
> > diff --git a/arch/x86/kvm/hyperv.c b/arch/x86/kvm/hyperv.c
> > index 7c2dac6824e2..9f1deb6aa131 100644
> > --- a/arch/x86/kvm/hyperv.c
> > +++ b/arch/x86/kvm/hyperv.c
> > @@ -729,7 +729,7 @@ static int stimer_set_count(struct kvm_vcpu_hv_stimer *stimer, u64 count,
> >       stimer->count = count;
> >       if (stimer->count == 0)
> >               stimer->config.enable = 0;
>
> Can this branch be problematic too? E.g. if STIMER[X]_CONFIG is
> deserialized after STIMER[X]_COUNT we may erroneously reset 'enable' to
> 0, right? In fact, when MSRs are ordered like this:
>
> #define HV_X64_MSR_STIMER0_CONFIG               0x400000B0
> #define HV_X64_MSR_STIMER0_COUNT                0x400000B1
>
> I would guess that we always de-serialize 'config' first. With
> auto-enable, the timer will get enabled when writing 'count' but what
> happens in other cases?
>
> Maybe the whole block needs to go under 'if (!host)' instead?

In either case, with 'enable == 1' && 'count == 0' we'll reset the timer
in 'kvm_hv_process_stimers()'. So it's unlikely to cause any weirdness.
That said, I think covering both cases is more correct. Will send a v2.

Nicolas