Re: [PATCH v6 09/34] gpu: nova-core: Hopper/Blackwell: skip GFW boot waiting

["Alexandre Courbot" <acourbot@nvidia.com>]

On Tue Mar 10, 2026 at 11:10 AM JST, John Hubbard wrote:
> Hopper and Blackwell GPUs use FSP-based secure boot and do not require
> waiting for GFW_BOOT completion. Skip this step for these architectures,
> and in fact for all future architectures, because we have moved on:
> there will not be any future GPUs using the older GFW_BOOT system.
>
> Cc: Danilo Krummrich <dakr@kernel.org>
> Signed-off-by: John Hubbard <jhubbard@nvidia.com>
> ---
>  drivers/gpu/nova-core/gpu.rs | 17 +++++++++++++----
>  1 file changed, 13 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/gpu/nova-core/gpu.rs b/drivers/gpu/nova-core/gpu.rs
> index efd1765b4f86..21a8c6c2d96b 100644
> --- a/drivers/gpu/nova-core/gpu.rs
> +++ b/drivers/gpu/nova-core/gpu.rs
> @@ -177,6 +177,15 @@ pub(crate) const fn dma_mask(&self) -> DmaMask {
>              Self::Hopper | Self::Blackwell => DmaMask::new::<52>(),
>          }
>      }
> +
> +    /// Returns whether the GPU uses GFW_BOOT for firmware loading.
> +    ///
> +    /// Pre-Hopper architectures (Turing, Ampere, Ada) require waiting for GFW_BOOT completion
> +    /// before any significant GPU setup. Hopper and later use the FSP Chain of Trust boot path
> +    /// instead.
> +    pub(crate) const fn needs_gfw_boot(&self) -> bool {
> +        matches!(self, Self::Turing | Self::Ampere | Self::Ada)
> +    }
>  }
>  
>  impl TryFrom<u8> for Architecture {
> @@ -322,11 +331,11 @@ pub(crate) fn new<'a>(
>              let chipset = spec.chipset();
>  
>              Ok(try_pin_init!(Self {
> -                // We must wait for GFW_BOOT completion before doing any significant setup
> -                // on the GPU.
>                  _: {
> -                    gfw::wait_gfw_boot_completion(bar)
> -                        .inspect_err(|_| dev_err!(pdev, "GFW boot did not complete\n"))?;
> +                    if chipset.arch().needs_gfw_boot() {
> +                        gfw::wait_gfw_boot_completion(bar)
> +                            .inspect_err(|_| dev_err!(pdev, "GFW boot did not complete\n"))?;
> +                    }

This looks like this should be a HAL method, wdyt?