Re: [PATCH 1/3] thermal: ti-soc-thermal: Fix stuck sensor with continuous mode for 4430

[Tony Lindgren <tony@atomide.com>]

* Péter Ujfalusi <peter.ujfalusi@gmail.com> [201231 12:55]:
> On 12/30/20 10:43 AM, Tony Lindgren wrote:
> > @@ -58,7 +58,8 @@ omap4430_adc_to_temp[OMAP4430_ADC_END_VALUE - OMAP4430_ADC_START_VALUE + 1] = {
> >  const struct ti_bandgap_data omap4430_data = {
> >  	.features = TI_BANDGAP_FEATURE_MODE_CONFIG |
> >  			TI_BANDGAP_FEATURE_CLK_CTRL |
> > -			TI_BANDGAP_FEATURE_POWER_SWITCH,
> > +			TI_BANDGAP_FEATURE_POWER_SWITCH |
> > +			TI_BANDGAP_FEATURE_CONT_MODE_ONLY,
> 
> Can we add a comment with the observations?

Sure, and I also noticed that the timeout triggers also on dra7
too. I need to recheck what all are affected.. At least we now
see warnings on the SoCs affected.

> > @@ -605,8 +606,10 @@ ti_bandgap_force_single_read(struct ti_bandgap *bgp, int id)
> >  	u32 counter = 1000;
> >  	struct temp_sensor_registers *tsr;
> >  
> > -	/* Select single conversion mode */
> > -	if (TI_BANDGAP_HAS(bgp, MODE_CONFIG))
> > +	/* Select continuous or single conversion mode */
> > +	if (TI_BANDGAP_HAS(bgp, CONT_MODE_ONLY))
> > +		RMW_BITS(bgp, id, bgap_mode_ctrl, mode_ctrl_mask, 1);
> > +	else if (TI_BANDGAP_HAS(bgp, MODE_CONFIG))
> >  		RMW_BITS(bgp, id, bgap_mode_ctrl, mode_ctrl_mask, 0);
> 
> Would not be better to:
> if (TI_BANDGAP_HAS(bgp, MODE_CONFIG)) {
> 	if (TI_BANDGAP_HAS(bgp, CONT_MODE_ONLY))
> 		RMW_BITS(bgp, id, bgap_mode_ctrl, mode_ctrl_mask, 1);
> 	else
> 		RMW_BITS(bgp, id, bgap_mode_ctrl, mode_ctrl_mask, 0);
> }
> 
> One can only switch to cont/single mode if the mode config is possible.

Yup makes sense thanks for spotting that.

Regards,

Tony