Re: [PATCH v2] media: uvcvideo: Recover stalled ElGato devices

[Sergey Senozhatsky <senozhatsky@chromium.org>]

On (22/12/02 18:01), Ricardo Ribalda wrote:
> Elgato Cam Link 4k can be in a stalled state if the resolution of
> the external source has changed while the firmware initializes.
> Once in this state, the device is useless until it receives a
> USB reset. It has even been observed that the stalled state will
> continue even after unplugging the device.
> 
> lsusb -v
> 
> Bus 002 Device 002: ID 0fd9:0066 Elgato Systems GmbH Cam Link 4K
> Device Descriptor:
>   bLength                18
>   bDescriptorType         1
>   bcdUSB               3.00
>   bDeviceClass          239 Miscellaneous Device
>   bDeviceSubClass         2
>   bDeviceProtocol         1 Interface Association
>   bMaxPacketSize0         9
>   idVendor           0x0fd9 Elgato Systems GmbH
>   idProduct          0x0066
>   bcdDevice            0.00
>   iManufacturer           1 Elgato
>   iProduct                2 Cam Link 4K
>   iSerial                 4 0005AC52FE000
>   bNumConfigurations      1
> 
> Signed-off-by: Ricardo Ribalda <ribalda@chromium.org>

Reviewed-by: Sergey Senozhatsky <senozhatsky@chromium.org>

>  
> +static const struct usb_device_id elgato_cam_link_4k = {
> +						USB_DEVICE(0x0fd9, 0x0066)};
> +

A nit, I'd format this slightly different:

+static const struct usb_device_id elgato_cam_link_4k = {
+	USB_DEVICE(0x0fd9, 0x0066)
+};