[PATCH 1/4] USB: serial: io_ti: drop closing_wait module parameter

Johan Hovold
2021-04-07T10:46:00Z

Now that all USB serial drivers supports setting the closing_wait
parameter through TIOCSSERIAL (setserial) it's time to drop the
corresponding io_ti module parameter.

Signed-off-by: Johan Hovold <johan@kernel.org>
---
drivers/usb/serial/io_ti.c | 6 +-----
1 file changed, 1 insertion(+), 5 deletions(-)

diff --git a/drivers/usb/serial/io_ti.c b/drivers/usb/serial/io_ti.c
index f548cdbf0a51..6eff0e5a7545 100644
--- a/drivers/usb/serial/io_ti.c
+++ b/drivers/usb/serial/io_ti.c
@@ -211,7 +211,6 @@ static const struct usb_device_id id_table_combined[] = {

MODULE_DEVICE_TABLE(usb, id_table_combined);

-static int closing_wait = EDGE_CLOSING_WAIT;
static bool ignore_cpu_rev;
static int default_uart_mode; /* RS232 */

@@ -2593,7 +2592,7 @@ static int edge_port_probe(struct usb_serial_port *port)
if (ret)
goto err;

- port->port.closing_wait = msecs_to_jiffies(closing_wait * 10);
+ port->port.closing_wait = msecs_to_jiffies(EDGE_CLOSING_WAIT * 10);
port->port.drain_delay = 1;

return 0;
@@ -2759,9 +2758,6 @@ MODULE_DESCRIPTION(DRIVER_DESC);
MODULE_LICENSE("GPL");
MODULE_FIRMWARE("edgeport/down3.bin");

-module_param(closing_wait, int, S_IRUGO | S_IWUSR);
-MODULE_PARM_DESC(closing_wait, "Maximum wait for data to drain, in .01 secs");
-
module_param(ignore_cpu_rev, bool, S_IRUGO | S_IWUSR);
MODULE_PARM_DESC(ignore_cpu_rev,
"Ignore the cpu revision when connecting to a device");
--
2.26.3