Re: [PATCH] USB:ohci:fix ohci interruption problem

[Greg KH <gregkh@linuxfoundation.org>]

On Fri, Apr 02, 2021 at 05:27:59PM +0800, Longfang Liu wrote:
> The operating method of the system entering S4 sleep mode:
> echo disk > /sys/power/state
> 
> When OHCI enters the S4 sleep state, the USB sleep process will call
> check_root_hub_suspend() and ohci_bus_suspend() instead of
> ohci_suspend() and ohci_bus_suspend(), this causes the OHCI interrupt
> to not be closed.
> 
> At this time, if just one device interrupt is reported. Since rh_state
> has been changed to OHCI_RH_SUSPENDED after ohci_bus_suspend(), the
> driver will not process and close this device interrupt. It will cause
> the entire system to be stuck during sleep, causing the device to
> fail to respond.
> 
> When the abnormal interruption reaches 100,000 times, the system will
> forcibly close the interruption and make the device unusable.
> 
> Because the root cause of the problem is that ohci_suspend is not
> called to perform normal interrupt shutdown operations when the system
> enters S4 sleep mode.
> 
> Therefore, our solution is to specify freeze interface in this mode to
> perform normal suspend_common() operations, and call ohci_suspend()
> after check_root_hub_suspend() is executed through the suspend_common()
> operation.
> After using this solution, it is verified by the stress test of sleep
> wake up in S4 mode for a long time that this problem no longer occurs.
> 
> Signed-off-by: Longfang Liu <liulongfang@huawei.com>
> ---
>  drivers/usb/core/hcd-pci.c | 7 ++++++-
>  1 file changed, 6 insertions(+), 1 deletion(-)

What changed from the previous version sent for this patch?  Always
properly describe the changes below the --- line, and also version your
subject line as documented.

Please fix up and resend.

thanks,

greg k-h