From: Alexandru Elisei <alexandru.elisei@arm.com>
To: davem@davemloft.net, michael.riesch@wolfvision.net,
peppe.cavallaro@st.com, alexandre.torgue@foss.st.com,
joabreu@synopsys.com, kuba@kernel.org, mcoquelin.stm32@gmail.com,
p.zabel@pengutronix.de, lgirdwood@gmail.com, broonie@kernel.org,
netdev@vger.kernel.org, linux-stm32@st-md-mailman.stormreply.com,
linux-arm-kernel@lists.infradead.org,
linux-kernel@vger.kernel.org
Cc: Alexandru Elisei <alexandru.elisei@arm.com>
Subject: [BUG RESEND] net: stmmac: dwmac-rk: Ethernet broken on rockpro64 by commit 2d26f6e39afb ("net: stmmac: dwmac-rk: fix unbalanced pm_runtime_enable warnings")
Date: Wed, 6 Oct 2021 16:58:11 +0100 [thread overview]
Message-ID: <YV3Hk2R4uDKbTy43@monolith.localdoman> (raw)
Resending this because my previous email client inserted HTML into the email,
which was then rejected by the linux-kernel@vger.kernel.org spam filter.
After commit 2d26f6e39afb ("net: stmmac: dwmac-rk: fix unbalanced
pm_runtime_enable warnings"), the network card on my rockpro64-v2 was left
unable to get a DHCP lease from the network. The offending commit was found by
bisecting the kernel; I tried reverting the commit from v5.15-rc4 and the
network card started working as expected.
I can help with testing a fix or further diagnosing if needed.
his is what I get with a kernel built from v5.15-rc4 (so with the commit *not*
reverted). Full dmesg at [1].
root@rockpro ~ # uname -a
Linux rockpro 5.15.0-rc4 #83 SMP PREEMPT Wed Oct 6 16:06:31 BST 2021 aarch64 GNU/Linux
root@rockpro ~ # ip a
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN group default qlen 1000
link/ether ce:71:c1:ee:97:e8 brd ff:ff:ff:ff:ff:ff
root@rockpro ~ # ip l set eth0 up
[ 33.398930] rk_gmac-dwmac fe300000.ethernet eth0: PHY [stmmac-0:00] driver [Generic PHY] (irq=POLL)
[ 33.404390] rk_gmac-dwmac fe300000.ethernet eth0: Register MEM_TYPE_PAGE_POOL RxQ-0
[ 33.405795] rk_gmac-dwmac fe300000.ethernet eth0: No Safety Features support found
[ 33.406479] rk_gmac-dwmac fe300000.ethernet eth0: PTP not supported by HW
[ 33.407528] rk_gmac-dwmac fe300000.ethernet eth0: configuring for phy/rgmii link mode
root@rockpro ~ # [ 37.503570] rk_gmac-dwmac fe300000.ethernet eth0: Link is Up - 1Gbps/Full - flow control rx/tx
root@rockpro ~ # ip a
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
link/ether ce:71:c1:ee:97:e8 brd ff:ff:ff:ff:ff:ff
root@rockpro ~ # dhclient --version
isc-dhclient-4.4.2-P1
root@rockpro ~ # dhclient -v eth0
Internet Systems Consortium DHCP Client 4.4.2-P1
Copyright 2004-2021 Internet Systems Consortium.
All rights reserved.
For info, please visit https://www.isc.org/software/dhcp/
Listening on LPF/eth0/ce:71:c1:ee:97:e8
Sending on LPF/eth0/ce:71:c1:ee:97:e8
Sending on Socket/fallback
DHCPREQUEST for 192.168.0.43 on eth0 to 255.255.255.255 port 67
DHCPREQUEST for 192.168.0.43 on eth0 to 255.255.255.255 port 67
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 8
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 7
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 20
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 20
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 6
No DHCPOFFERS received.
Trying recorded lease 192.168.0.43
ping: socket: Address family not supported by protocol
PING 192.168.0.1 (192.168.0.1) 56(84) bytes of data.
--- 192.168.0.1 ping statistics ---
1 packets transmitted, 0 received, +1 errors, 100% packet loss, time 0ms
No working leases in persistent database - sleeping.
With the commit reverted, the NIC is working again (dmesg at [2]).
root@rockpro ~ # uname -a
Linux rockpro 5.15.0-rc4-00001-g6ac1832b7cc5 #84 SMP PREEMPT Wed Oct 6 16:24:54 BST 2021 aarch64 GNU/Linux
root@rockpro ~ # ip a
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN group default qlen 1000
link/ether ce:71:c1:ee:97:e8 brd ff:ff:ff:ff:ff:ff
root@rockpro ~ # ip l set eth0 up
[ 76.094639] rk_gmac-dwmac fe300000.ethernet eth0: PHY [stmmac-0:00] driver [Generic PHY] (irq=POLL)
[ 76.100233] rk_gmac-dwmac fe300000.ethernet eth0: Register MEM_TYPE_PAGE_POOL RxQ-0
[ 76.101646] rk_gmac-dwmac fe300000.ethernet eth0: No Safety Features support found
[ 76.102374] rk_gmac-dwmac fe300000.ethernet eth0: PTP not supported by HW
[ 76.103335] rk_gmac-dwmac fe300000.ethernet eth0: configuring for phy/rgmii link mode
root@rockpro ~ # [ 80.191353] rk_gmac-dwmac fe300000.ethernet eth0: Link is Up - 1Gbps/Full - flow control rx/tx
root@rockpro ~ # ip a
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
link/ether ce:71:c1:ee:97:e8 brd ff:ff:ff:ff:ff:ff
root@rockpro ~ # dhclient --version
isc-dhclient-4.4.2-P1
root@rockpro ~ # dhclient -v eth0
Internet Systems Consortium DHCP Client 4.4.2-P1
Copyright 2004-2021 Internet Systems Consortium.
All rights reserved.
For info, please visit https://www.isc.org/software/dhcp/
Listening on LPF/eth0/ce:71:c1:ee:97:e8
Sending on LPF/eth0/ce:71:c1:ee:97:e8
Sending on Socket/fallback
DHCPREQUEST for 192.168.0.43 on eth0 to 255.255.255.255 port 67
DHCPACK of 192.168.0.43 from 192.168.0.1
bound to 192.168.0.43 -- renewal in 36072 seconds.
root@rockpro ~ # ip a
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
link/ether ce:71:c1:ee:97:e8 brd ff:ff:ff:ff:ff:ff
inet 192.168.0.43/24 brd 192.168.0.255 scope global eth0
valid_lft forever preferred_lft forever
root@rockpro ~ # ping google.com
ping: socket: Address family not supported by protocol
PING google.com (172.217.169.46) 56(84) bytes of data.
64 bytes from lhr48s08-in-f14.1e100.net (172.217.169.46): icmp_seq=1 ttl=117 time=21.7 ms
64 bytes from lhr48s08-in-f14.1e100.net (172.217.169.46): icmp_seq=2 ttl=117 time=19.1 ms
--- google.com ping statistics ---
2 packets transmitted, 2 received, 0% packet loss, time 1001ms
rtt min/avg/max/mdev = 19.058/20.392/21.726/1.334 ms
Pastebins will expire after 6 months.
[1] https://pastebin.com/JrViZTPe
[2] https://pastebin.com/EwEbWRfY
Thanks,
Alex
next reply other threads:[~2021-10-06 15:56 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2021-10-06 15:58 Alexandru Elisei [this message]
2021-10-06 17:32 ` [BUG RESEND] net: stmmac: dwmac-rk: Ethernet broken on rockpro64 by commit 2d26f6e39afb ("net: stmmac: dwmac-rk: fix unbalanced pm_runtime_enable warnings") Mark Brown
2021-10-07 0:33 ` Jakub Kicinski
2021-10-07 9:30 ` Alexandru Elisei
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=YV3Hk2R4uDKbTy43@monolith.localdoman \
--to=alexandru.elisei@arm.com \
--cc=alexandre.torgue@foss.st.com \
--cc=broonie@kernel.org \
--cc=davem@davemloft.net \
--cc=joabreu@synopsys.com \
--cc=kuba@kernel.org \
--cc=lgirdwood@gmail.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-stm32@st-md-mailman.stormreply.com \
--cc=mcoquelin.stm32@gmail.com \
--cc=michael.riesch@wolfvision.net \
--cc=netdev@vger.kernel.org \
--cc=p.zabel@pengutronix.de \
--cc=peppe.cavallaro@st.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox