Re: [PATCH v4] phy: dphy: Correct clk_pre parameter

[Vinod Koul <vkoul@kernel.org>]

On 24-01-22, 10:40, Liu Ying wrote:
> The D-PHY specification (v1.2) explicitly mentions that the T-CLK-PRE
> parameter's unit is Unit Interval(UI) and the minimum value is 8.  Also,
> kernel doc of the 'clk_pre' member of struct phy_configure_opts_mipi_dphy
> mentions that it should be in UI.  However, the dphy core driver wrongly
> sets 'clk_pre' to 8000, which seems to hint that it's in picoseconds.
> 
> So, let's fix the dphy core driver to correctly reflect the T-CLK-PRE
> parameter's minimum value according to the D-PHY specification.
> 
> I'm assuming that all impacted custom drivers shall program values in
> TxByteClkHS cycles into hardware for the T-CLK-PRE parameter.  The D-PHY
> specification mentions that the frequency of TxByteClkHS is exactly 1/8
> the High-Speed(HS) bit rate(each HS bit consumes one UI).  So, relevant
> custom driver code is changed to program those values as
> DIV_ROUND_UP(cfg->clk_pre, BITS_PER_BYTE), then.
> 
> Note that I've only tested the patch with RM67191 DSI panel on i.MX8mq EVK.
> Help is needed to test with other i.MX8mq, Meson and Rockchip platforms,
> as I don't have the hardwares.

Applied, thanks

-- 
~Vinod