From: "Gautham R. Shenoy" <gautham.shenoy@amd.com>
To: Mario Limonciello <superm1@kernel.org>
Cc: Perry Yuan <perry.yuan@amd.com>,
Dhananjay Ugwekar <Dhananjay.Ugwekar@amd.com>,
"open list:X86 ARCHITECTURE (32-BIT AND 64-BIT)"
<linux-kernel@vger.kernel.org>,
"open list:CPU FREQUENCY SCALING FRAMEWORK"
<linux-pm@vger.kernel.org>,
Mario Limonciello <mario.limonciello@amd.com>,
Miroslav Pavleski <miroslav@pavleski.net>
Subject: Re: [PATCH v3 01/18] cpufreq/amd-pstate: Invalidate cppc_req_cached during suspend
Date: Wed, 19 Feb 2025 10:54:16 +0530 [thread overview]
Message-ID: <Z7VrADfrrPB7GtfX@BLRRASHENOY1.amd.com> (raw)
In-Reply-To: <20250217220707.1468365-2-superm1@kernel.org>
Hello Mario,
On Mon, Feb 17, 2025 at 04:06:50PM -0600, Mario Limonciello wrote:
> From: Mario Limonciello <mario.limonciello@amd.com>
>
> During resume it's possible the firmware didn't restore the CPPC request MSR
> but the kernel thinks the values line up. This leads to incorrect performance
> after resume from suspend.
>
> To fix the issue invalidate the cached value at suspend. During resume use
> the saved values programmed as cached limits.
>
> Reported-by: Miroslav Pavleski <miroslav@pavleski.net>
> Closes: https://bugzilla.kernel.org/show_bug.cgi?id=217931
> Signed-off-by: Mario Limonciello <mario.limonciello@amd.com>
> ---
> drivers/cpufreq/amd-pstate.c | 5 ++++-
> 1 file changed, 4 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/cpufreq/amd-pstate.c b/drivers/cpufreq/amd-pstate.c
> index f425fb7ec77d7..12fb63169a24c 100644
> --- a/drivers/cpufreq/amd-pstate.c
> +++ b/drivers/cpufreq/amd-pstate.c
> @@ -1611,7 +1611,7 @@ static int amd_pstate_epp_reenable(struct cpufreq_policy *policy)
> max_perf, policy->boost_enabled);
> }
You can also remove the tracing code from amd_pstate_epp_reenable(), i.e,
if (trace_amd_pstate_epp_perf_enabled()) {
trace_amd_pstate_epp_perf(cpudata->cpu, cpudata->highest_perf,
cpudata->epp_cached,
FIELD_GET(AMD_CPPC_MIN_PERF_MASK, cpudata->cppc_req_cached),
max_perf, policy->boost_enabled);
}
Since amd_pstate_epp_update_limit() also has the the tracing code.
The patch looks good to me otherwise.
Reviewed-by: Gautham R. Shenoy <gautham.shenoy@amd.com>
--
Thanks and Regards
gautham.
>
> - return amd_pstate_update_perf(cpudata, 0, 0, max_perf, cpudata->epp_cached, false);
> + return amd_pstate_epp_update_limit(policy);
> }
>
> static int amd_pstate_epp_cpu_online(struct cpufreq_policy *policy)
> @@ -1660,6 +1660,9 @@ static int amd_pstate_epp_suspend(struct cpufreq_policy *policy)
> if (cppc_state != AMD_PSTATE_ACTIVE)
> return 0;
>
> + /* invalidate to ensure it's rewritten during resume */
> + cpudata->cppc_req_cached = 0;
> +
> /* set this flag to avoid setting core offline*/
> cpudata->suspended = true;
>
> --
> 2.43.0
>
next prev parent reply other threads:[~2025-02-19 5:24 UTC|newest]
Thread overview: 35+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-02-17 22:06 [PATCH v3 00/18] amd-pstate cleanups Mario Limonciello
2025-02-17 22:06 ` [PATCH v3 01/18] cpufreq/amd-pstate: Invalidate cppc_req_cached during suspend Mario Limonciello
2025-02-19 5:24 ` Gautham R. Shenoy [this message]
2025-02-19 17:21 ` Mario Limonciello
2025-02-19 6:12 ` Dhananjay Ugwekar
2025-02-19 6:37 ` Dhananjay Ugwekar
2025-02-17 22:06 ` [PATCH v3 02/18] cpufreq/amd-pstate: Show a warning when a CPU fails to setup Mario Limonciello
2025-02-19 6:14 ` Dhananjay Ugwekar
2025-02-17 22:06 ` [PATCH v3 03/18] cpufreq/amd-pstate: Drop min and max cached frequencies Mario Limonciello
2025-02-19 5:25 ` Gautham R. Shenoy
2025-02-19 8:00 ` Dhananjay Ugwekar
2025-02-19 17:29 ` Mario Limonciello
2025-02-17 22:06 ` [PATCH v3 04/18] cpufreq/amd-pstate: Move perf values into a union Mario Limonciello
2025-02-19 10:57 ` Dhananjay Ugwekar
2025-02-25 0:29 ` Mario Limonciello
2025-02-25 4:28 ` Dhananjay Ugwekar
2025-02-17 22:06 ` [PATCH v3 05/18] cpufreq/amd-pstate: Overhaul locking Mario Limonciello
2025-02-17 22:06 ` [PATCH v3 06/18] cpufreq/amd-pstate: Drop `cppc_cap1_cached` Mario Limonciello
2025-02-17 22:06 ` [PATCH v3 07/18] cpufreq/amd-pstate-ut: Use _free macro to free put policy Mario Limonciello
2025-02-17 22:06 ` [PATCH v3 08/18] cpufreq/amd-pstate-ut: Allow lowest nonlinear and lowest to be the same Mario Limonciello
2025-02-17 22:06 ` [PATCH v3 09/18] cpufreq/amd-pstate-ut: Drop SUCCESS and FAIL enums Mario Limonciello
2025-02-17 22:06 ` [PATCH v3 10/18] cpufreq/amd-pstate-ut: Run on all of the correct CPUs Mario Limonciello
2025-02-19 5:26 ` Gautham R. Shenoy
2025-02-17 22:07 ` [PATCH v3 11/18] cpufreq/amd-pstate-ut: Adjust variable scope for amd_pstate_ut_check_freq() Mario Limonciello
2025-02-24 6:12 ` Dhananjay Ugwekar
2025-02-17 22:07 ` [PATCH v3 12/18] cpufreq/amd-pstate: Replace all AMD_CPPC_* macros with masks Mario Limonciello
2025-02-17 22:07 ` [PATCH v3 13/18] cpufreq/amd-pstate: Cache CPPC request in shared mem case too Mario Limonciello
2025-02-17 22:07 ` [PATCH v3 14/18] cpufreq/amd-pstate: Move all EPP tracing into *_update_perf and *_set_epp functions Mario Limonciello
2025-02-17 22:07 ` [PATCH v3 15/18] cpufreq/amd-pstate: Update cppc_req_cached for shared mem EPP writes Mario Limonciello
2025-02-17 22:07 ` [PATCH v3 16/18] cpufreq/amd-pstate: Drop debug statements for policy setting Mario Limonciello
2025-02-17 22:07 ` [PATCH v3 17/18] cpufreq/amd-pstate: Rework CPPC enabling Mario Limonciello
2025-02-19 15:25 ` Gautham R. Shenoy
2025-02-19 18:05 ` Mario Limonciello
2025-02-17 22:07 ` [PATCH v3 18/18] cpufreq/amd-pstate: Stop caching EPP Mario Limonciello
2025-02-19 15:41 ` Gautham R. Shenoy
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=Z7VrADfrrPB7GtfX@BLRRASHENOY1.amd.com \
--to=gautham.shenoy@amd.com \
--cc=Dhananjay.Ugwekar@amd.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-pm@vger.kernel.org \
--cc=mario.limonciello@amd.com \
--cc=miroslav@pavleski.net \
--cc=perry.yuan@amd.com \
--cc=superm1@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox