[PATCH net v1 1/1] net: dsa: microchip: make sure drive strength configuration is not lost by soft reset

Oleksij Rempel
2024-03-04T13:56:22Z

This driver has two separate reset sequence in different places:
- gpio/HW reset on start of ksz_switch_register()
- SW reset on start of ksz_setup()

The second one will overwrite drive strength configuration made in the
ksz_switch_register().

To fix it, move ksz_parse_drive_strength() from ksz_switch_register() to
ksz_setup().

Fixes: d67d7247f641 ("net: dsa: microchip: Add drive strength configuration")
Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de>
---
drivers/net/dsa/microchip/ksz_common.c | 10 ++++++----
1 file changed, 6 insertions(+), 4 deletions(-)

diff --git a/drivers/net/dsa/microchip/ksz_common.c b/drivers/net/dsa/microchip/ksz_common.c
index d58cc685478b1..83a5936506059 100644
--- a/drivers/net/dsa/microchip/ksz_common.c
+++ b/drivers/net/dsa/microchip/ksz_common.c
@@ -2260,6 +2260,8 @@ static int ksz_pirq_setup(struct ksz_device *dev, u8 p)
return ksz_irq_common_setup(dev, pirq);
}

+static int ksz_parse_drive_strength(struct ksz_device *dev);
+
static int ksz_setup(struct dsa_switch *ds)
{
struct ksz_device *dev = ds->priv;
@@ -2281,6 +2283,10 @@ static int ksz_setup(struct dsa_switch *ds)
return ret;
}

+ ret = ksz_parse_drive_strength(dev);
+ if (ret)
+ return ret;
+
/* set broadcast storm protection 10% rate */
regmap_update_bits(ksz_regmap_16(dev), regs[S_BROADCAST_CTRL],
BROADCAST_STORM_RATE,
@@ -4345,10 +4351,6 @@ int ksz_switch_register(struct ksz_device *dev)
for (port_num = 0; port_num < dev->info->port_cnt; ++port_num)
dev->ports[port_num].interface = PHY_INTERFACE_MODE_NA;
if (dev->dev->of_node) {
- ret = ksz_parse_drive_strength(dev);
- if (ret)
- return ret;
-
ret = of_get_phy_mode(dev->dev->of_node, &interface);
if (ret == 0)
dev->compat_interface = interface;
--
2.39.2