Re: [PATCH v1 08/13] iio: chemical: bme680: add power management

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

On Thu, Oct 10, 2024 at 11:00:25PM +0200, vamoirid wrote:
> From: Vasileios Amoiridis <vassilisamir@gmail.com>
> 
> Add runtime power management to the device. To facilitate this, add also
> a struct dev * inside the bme680_data structure to have the device
> accesible from the data structure.

...

> --- a/drivers/iio/chemical/bme680.h
> +++ b/drivers/iio/chemical/bme680.h
> @@ -75,6 +75,7 @@
>  #define BME680_CALIB_RANGE_3_LEN               5
>  
>  extern const struct regmap_config bme680_regmap_config;
> +extern const struct dev_pm_ops bmp280_dev_pm_ops;

Is pm.h being included already in this header? Otherwise you need to add it.

...

>  	struct regmap *regmap;
>  	struct bme680_calib bme680;
>  	struct mutex lock; /* Protect multiple serial R/W ops to device. */
> +	struct device *dev;

Is it the same that you may get wia regmap_get_device()?

>  	u8 oversampling_temp;
>  	u8 oversampling_press;
>  	u8 oversampling_humid;

...

> +	/* Enable runtime PM */
> +	pm_runtime_get_noresume(dev);
> +	pm_runtime_set_active(dev);
> +	pm_runtime_enable(dev);
> +	pm_runtime_set_autosuspend_delay(dev, BME680_STARTUP_TIME_US * 100);
> +	pm_runtime_use_autosuspend(dev);
> +	pm_runtime_put(dev);

Can we use devm_pm_runtime_enable() for some of the above?

> +	ret = devm_add_action_or_reset(dev, bme680_pm_disable, dev);
> +	if (ret)
> +		return ret;

...

> +static int bme680_runtime_resume(struct device *dev)
> +{
> +	struct iio_dev *indio_dev = dev_get_drvdata(dev);
> +	struct bme680_data *data = iio_priv(indio_dev);
> +	int ret;
> +
> +	ret = regulator_bulk_enable(BME680_NUM_SUPPLIES, data->supplies);
> +	if (ret)
> +		return ret;
> +
> +	fsleep(BME680_STARTUP_TIME_US);
> +
> +	ret = bme680_chip_config(data);
> +	if (ret)
> +		return ret;

> +	ret = bme680_gas_config(data);
> +	if (ret)
> +		return ret;
> +
> +	return 0;

	return bme680_gas_config(...);

> +}

...

> +EXPORT_RUNTIME_DEV_PM_OPS(bme680_dev_pm_ops, bme680_runtime_suspend,
> +			  bme680_runtime_resume, NULL);

You also need pm.h for the macro IIRC.

-- 
With Best Regards,
Andy Shevchenko