Re: [PATCH v3 0/6] net: dsa: lantiq_gswip: prepare for supporting MaxLinear GSW1xx

[Daniel Golle <daniel@makrotopia.org>]

On Fri, Aug 29, 2025 at 02:01:36PM +0100, Daniel Golle wrote:
> Continue to prepare for supporting the newer standalone MaxLinear GSW1xx
> switch family by extending the existing lantiq_gswip driver to allow it
> to support MII interfaces and MDIO bus of the GSW1xx.
> 
> This series has been preceded by an RFC series which covers everything
> needed to support the MaxLinear GSW1xx family of switches. Andrew Lunn
> had suggested to split it into a couple of smaller series and start
> with the changes which don't yet make actual functional changes or
> support new features.
> 
> Everything has been compile and runtime tested on AVM Fritz!Box 7490
> (GSWIP version 2.1, VR9 v1.2)
> 
> Link: https://lore.kernel.org/netdev/aKDhFCNwjDDwRKsI@pidgin.makrotopia.org/
> 
> v3: explicitly initialize mii_port_reg_offset to 0
> v2: move lantiq_gswip driver to its own folder
> 
> Daniel Golle (6):
>   net: dsa: lantiq_gswip: move to dedicated folder
>   net: dsa: lantiq_gswip: support model-specific mac_select_pcs()
>   net: dsa: lantiq_gswip: ignore SerDes modes in phylink_mac_config()
>   net: dsa: lantiq_gswip: support offset of MII registers
>   net: dsa: lantiq_gswip: support standard MDIO node name
>   net: dsa: lantiq_gswip: move MDIO bus registration to .setup()

The whole series is intended for net-next, I messed up putting that into
the subject line. Let me know if I should resend another time for that or
if it is fine to go into net-next like that.